User Manual

SD Card
Cannot insert the SD card.
0
Make sure not to insert the SD card in the wrong direction.
“Inserting an SD Card” (A p. 8)
0
Do
not use a miniSD card or microSD card on this unit (even if the card is
inserted in an adapter). It may cause malfunction.
“Types of Usable SD Card” (A p. 8)
Unable to copy to SD card.
0
To use a new SD card or SD card that was used on other devices, it is
necessary
to format (initialize) the SD card using “Format SD Card” in the
“System” menu.
“ Format SD Card ” (A p. 114)
0
When “Check Card's Write Protection Switch” appears, release the lock
on the SD card.
.
SD card cannot be removed.
0
The inability to remove the SD card may be due to adhesion of dust, etc.
Use a pair of tweezers to pull out the SD card, remove the dust and then
re-insert the card.
Playback
Sound or video is interrupted.
0
Sometimes
playback is interrupted at the connecting section between two
scenes. This is not a malfunction.
There is no sound.
0
When the Silent mode is used, operation sounds will not be output. Turn
off the Silent mode.
“ Silent Mode ” (A p. 114
)
0
Operation sound is not output when “Operation Sound” is set to “Off”.
Select “Low” or “High”.
“ Operation Sound ” (A p. 113)
0
Audio sound is not recorded for videos taken in High-Speed.
“Slow-motion (High-speed) Recording” (A p. 34)
0
Audio sound is not recorded for videos taken in Time-Lapse Rec.
“Time-lapse Recording (Time-Lapse Rec)” (A p. 41)
The same image is displayed for a long time.
0
Clean the terminals of the SD card with a dry cotton swab or something
similar.
0
Execute
“Format SD Card” in the “System” menu. (All data will be deleted.)
“ Format SD Card ” (A p. 114)
The motion is choppy.
0
Clean the terminals of the SD card with a dry cotton swab or something
similar.
0
Execute
“Format SD Card” in the “System” menu. (All data will be deleted.)
“ Format SD Card ” (A p. 114)
0
Verify the system requirements of your PC when using CyberLink
PowerDirector to play back.
“Verifying System Requirements (Guideline)” (A p. 74)
Images do not appear on the TV properly.
0
Disconnect the cable and connect again.
“Connecting via the HDMI Mini Connector” (A p. 57)
0
Reset this unit.
“Resetting this Unit” (A p. 131)
Images are projected vertically on the TV.
0
Adjust the TV's screen accordingly.
When connected to the TV via the HDMI mini cable, proper
images and sounds are not output.
0
Images and sounds may not be output properly depending on the TV
connected. In such cases, perform the following operations.
A
Disconnect the HDMI mini cable and connect it again.
“Connecting via the HDMI Mini Connector” (A p. 57)
When connected to the TV via the HDMI mini cable, displays
such as buttons on the screen are slow to appear.
0
Depending on the type of TV connected, this symptom is normal and not
a malfunction.
Troubleshooting
133