User Manual

CHARGE lamp and POWER/ACCESS lamp are blinking and
operation is disabled
0
Close
the monitor screen to turn off the power and remove the AC adapter,
then press the Reset button to reset this unit.
“Resetting this Unit” (A p. 131)
0
If these operations won’t solve the problem, contact your JVC dealer or
the JVC service center.
Disclaimer
0
We shall not be liable for any loss of recorded contents when videos or
audio cannot be recorded or played back properly due to malfunction of
this unit and accessories that come with it or the SD card.
0
Recorded contents (data) that are lost, including loss due to malfunction
of this unit, cannot be restored. Please be forewarned.
0
JVC will not be responsible for any lost data. Please be forewarned.
0
Defective recordable media that have been replaced may be used in our
analysis
for the purpose of quality improvement. Therefore, it may not be
returned.
Error Message
No Media/No Media
0
Insert an SD card into one of the card slots or both slots.
Formatting Required
0
Remove
the SD card, back up the data on a PC, and insert the card again.
Tap “Yes” when the formatting confirmation screen appears.
Check the Speed Class or Type of the Card
0
Check that the card is supported by this unit.
“Types of Usable SD Card” (A p. 8)
Recording Failure
0
Reset this unit.
“Resetting this Unit” (A p. 131)
Turn on the function in the menu to split the file into units of
4 GB.
0
Recording is not possible with SD cards other than those of the SDXC
format when “4 GB Spanning” is “Off”.
To
perform recording with “4 GB Spanning” set to “On”, use an SDXC card.
This Card Cannot Be Used for Recording or Editing on This
Camera
0
The
Frame Rate set on this unit is different from the Frame Rate recorded
in the SD card. Please change the Frame Rate.
0
After backing up the data, run “Format SD Card” from the “System” menu.
Check Card's Write Protection Switch
0
Set the write protect switch of the SD card to off.
Media Full!
0
Delete files, or move files to a computer or other devices.
0
Replace the SD card with a new one.
Scene Quantity Limit Exceeded
0
Move
the files or folders to a computer or other device. (Back up your files.)
File Quantity Limit Exceeded
0
Move
the files or folders to a computer or other device. (Back up your files.)
Camera Temperature Is Too High, Power Will Turn Off to
Protect the Camera
0
Turn on the power after the camera has cooled down.
Troubleshooting
136