Operation Manual
advanced features 39
Editing Using Another VCR
connect up Connect the player’s 21-pin SCART connector to the recorder’s
21-pin SCART connector as illustrated.
A When using your VCR as the player ...
... connect its
L-1 IN/OUT connector to another VCR.
B When using your VCR as the recorder ...
... connect its
L-2 IN/DECODER or L-1 IN/OUT connector to another VCR.
set vcr’s input mode The recording VCR mode must be set to AUX. If this
VCR is the recorder, press
AUX and/or PR to select L-1 (if you’ve used the L-1 IN/
OUT
connector) or L-2 (if you’ve used the L-2 IN/DECODER connector). If this
VCR is the player, set
O.S.D. to OFF. (墌 pg.42)
set edit mode See Picture Control on page31.
start source vcr Engage its PLAY mode.
start recording vcr Engage its RECORD mode.
NOTES:
• All necessary cables can be obtained from your dealer.
• For Y/C signal input/output, be sure to use a 21-pin SCART cable that is
compatible with the Y/C signal.
• When you set
PICTURE CONTROL to EDIT to dub tapes (墌 pg.31), be sure to
select
AUTO (or NORM when B.E.S.T. is set to OFF) after you finish dubbing the
tapes.
HR-S6955EK-EN/p29-41 3/13/02, 05:07 PM39