User Manual

2 3
Memo :
● Other than when attaching or detaching the camera, be sure
to tighten the two screws on the sides. It could be dangerous
especially during transportation when it is more unstable.
Make sure that the screws are fixed in place before
transporting.
● Be careful not to get your fingers caught when opening and
closing this unit.
1 Mount this unit on your tripod using a suitable mounting
hole
Memo :
● For your safety, use a tripod that is able to withstand a load of
20 kg and above.
2 Loosen the two screws on the sides and open this unit
3 Check that the front mount clip is not sticking out
If the clip is sticking out, pull the lock lever while pressing the
safety lever to release the lock.
4 Align the mounting bracket with the pin position and
slide the camera forward
Attach the camera by sliding firmly until it clicks into place.
5 Connect the cables and close this unit
6 Tighten the two screws on the sides firmly
7 Bundle the cables
If necessary, remove the cap and bundle the cables with a cable
clamp.
8 Attach VF-HP790G and other accessories when
necessary
Memo :
● For details, refer to the [INSTRUCTIONS] of VF-HP790G.
Installation
2
1
2
To Tr i p o d
Open
Safety Lever
Lock Lever
Locked
Released
Front Mount Clip
Click
Rear Mounting Bracket
Front Mounting Bracket
Pin
5
6
6
Close
7
Cap
Cable Clamp