Operation Manual

ENGLISH
5
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
GETTING STARTED
For key layout on the faceplate, see page3 or page4.
Cancel the demonstration
When you turn on the power for the first time (or after you reset the unit),
the display shows:
KD-R691 / KD-R491 :
“CANCEL DEMO”
“PRESS ENTER”
1 Press .
[YES] is selected for the initial setup.
2 Press again.
“DEMO OFF” appears.
KD-R499 / KD-R494 / KD-R492 :
“CANCEL DEMO”
“PRESS” “VOLUME KNOB”
1 Press the volume knob.
[YES] is selected for the initial setup.
2 Press the volume knob again.
“DEMO OFF” appears.
Set the clock and date
1
Press and hold .
2 Perform ‘select an item ( 3 or 4)’ operation to select [CLOCK] .
3 Perform ‘select an item ( 3 or 4)’ operation to adjust the clock.
[CLOCK ADJUST] set the hour and minute [CLOCK FORMAT]
[12H]
or [24H]
4 Perform ‘select an item ( 3 or 4)’ operation to set the date.
[DATE SET] set the day, month and year
5 Press to exit.
To return to the previous setting item, press .
1
Set the basic settings
1
Press and hold .
2 Perform 'select an item ( 3 or 4)’ operation to select an
item (see the following table).
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press .
Default:
XX
SYSTEM
KEY BEEP
ON :Activates the keypress tone.; OFF :Deactivates.
SOURCE SELECT
AM SRC
*
ON :Enables AM in source selection.; OFF :Disables. ( 6)
BUILT-IN AUX
*
ON :Enables AUX in source selection.; OFF :Disables. ( 8)
F/W UPDATE
UPDATE SYSTEM
F/W UP xxxx
YES :Starts upgrading the firmware.; NO :Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
*
Not displayed when the corresponding source is selected.
2
3
JS_JVC_KD_R691_E_EN_4.indd 5JS_JVC_KD_R691_E_EN_4.indd 5 7/10/2017 2:42:02 PM7/10/2017 2:42:02 PM