Owner's Manual

32
ENGLISH
REFERENCES
Maintenance
Cleaning the unit
Wipe off dirt on the faceplate with a dry silicone or soft cloth.
Cleaning the connector
Detach the faceplate and clean the
connector gently with a cotton swab, being
careful not to damage the connector.
Handling discs:
• Do not touch the recording surface of the disc.
• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
• Do not use any accessories for the disc.
• Clean from the center of the disc and move outward.
• Clean the disc with a dry silicone or soft cloth. Do not use any solvents.
• When removing discs from this unit, pull them out horizontally.
• Remove burrs from the center hole and disc edge before inserting a disc.
More information
For: – Latest firmware updates and latest compatible item list
– JVC original application
– Any other latest information
Visit <http://www.jvc.net/cs/car/>.
General
• This unit can only play the following CDs:
• DualDisc playback: The Non-DVD side of a “DualDisc” does not comply with the
“Compact Disc Digital Audio” standard. Therefore, the use of Non-DVD side of a
DualDisc on this product cannot be recommended.
• For detailed information and notes about the playable audio files, visit
<http://www.jvc.net/cs/car/>.
Connector (on the reverse
side of the faceplate)
LEARNING STEERING REMOTE CONTROL (for KD-R792BT)
6 Press and hold any control keys on your steering remote control which
you want to assign.
A list of key functions will appear on the display.
NONE (default) / MUTE / SEEK UP / SEEK DOWN / VOL UP / VOL DOWN / MODE / ON HOOK /
OFF HOOK / VOICE / ENTER
7 Turn the volume knob to select a function to assign, then press the knob.
The selected key function is assigned to the steering remote control key you
have selected in step 6.
The display returns to the key list as on step 4.
• K## (Function) : When certain function has been assigned to a key.
8 Repeat steps 5, 6 and 7 to assign other control keys.
9 Press to exit.
To reassign the control keys
1
Press and hold .
2 Turn the volume knob to select [SYSTEM] , then press the knob.
3 Turn the volume knob to select [USER S.REMO] , then press the knob.
4 Turn the volume knob to select [RESET KEY] , then press the knob.
5 Turn the volume knob to select [YES] , then press the knob.
All the control keys will be reset.
Selecting
[NO] will cancel the operation.
When
[FACTORY RESET] is set to [YES] ( 5) , it will also reset the learning remote
control.
To return to the previous setting item, press
.
JS_JVC_KD_R995BTS_K_EN_03.indd 32 7/18/2017 12:05:15 PM