Owner's Manual

4
GETTING STARTED
Cancel the demonstration
When you turn on the power for the first time (or [ FACTORY RST ] is set to
[
YES ]), the display shows: “CANCEL DEMO” “PRESS” “VOLUME KNOB”
1 Press the volume knob.
[
YES ] is selected for the initial setup.
2 Press the volume knob again.
“DEMO OFF” appears.
Set the clock
1
Press and hold .
2 Turn the volume knob to select [ CLOCK ], then press the knob.
3 Turn the volume knob to select [ CLOCKSET ], then press the knob.
4 Turn the volume knob to make the settings, then press the knob.
Day
Hour Minute
5 Turn the volume knob to select [ 24H/ 12H ], then press the knob.
6 Turn the volume knob to select [ 12 HOUR ] or [ 24 HOUR ], then press the
knob.
7 Press to exit.
To return to the previous setting item, press
.
1
2
Set the basic settings
1
Press and hold .
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press
.
Default:
XX
SETTINGS
BEEP
(Not applicable when 3-way crossover is selected.)
ON :Activates the keypress tone.; OFF :Deactivates.
SRC SELECT
AM
* ON :Enables AM in source selection.; OFF :Disables.
PANDORA * ON :Enables PANDORA/PANDORA-F/PANDORA-R in source selection.;
OFF :Disables.
IHEART * ON :Enables IHEARTRADIO/IHEART FRONT/IHEART REAR in source selection.;
OFF :Disables.
AUX * ON :Enables AUX in source selection.; OFF :Disables.
F/W UPDATE
SYSTEM
F/W xxxx
YES :Starts upgrading the firmware.; NO :Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
FACTORY RST YES :Resets the settings to default (except the stored station).; NO :Cancels.
* Not displayed when the corresponding source is selected.
3
JS_JVC_KD_R975BTS_K_EN_10_ff.indd 4 9/10/2015 2:21:16 PM