Owner's Manual

ENGLISH
5
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Remote control (RM-RK52) (for KD-T925BTS/KD-T920BTS)
This unit can be remotely controlled with an optionally purchased remote
control.
How to replace the battery
To On the remote control
Adjust the volume Press VOL + or VOL – .
• Press and hold VOL + to continuously increase
the volume to 15.
Press d to mute the sound or pause playback.
• Press again to cancel. The volume level returns to
the previous level before muting or pause.
Select a source Press SOURCE repeatedly.
Remote sensor (Do not expose to bright sunlight.)
Pull out the insulation sheet
when using for the first time.
Basics Getting Started
Acknowledge the crossover type and cancel the
demonstration
When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES] , see page6), the display shows: “2-WAY X’OVER” or “3-WAY X’OVER”
“PRESS” “VOLUME KNOB” “TO CONFIRM”.
1 Press the volume knob to acknowledge the current crossover type.
Then, the display shows: “CANCEL DEMO” “PRESS” “VOLUME KNOB”.
• To change the crossover type, see page27.
2 Press the volume knob.
[YES] is selected for the initial setup.
3 Press the volume knob again.
“DEMO OFF” appears.
Set the clock and date
1
Press and hold .
2 Turn the volume knob to select [CLOCK] , then press the knob.
To adjust the clock
3 Turn the volume knob to select [CLOCKADJUST] , then press the knob.
4 Turn the volume knob to make the settings, then press the knob.
Set the time in the order of “Hour” “Minute”.
5 Turn the volume knob to select [CLOCK FORMAT] , then press the knob.
6 Turn the volume knob to select [12H] or [24H] , then press the knob.
1
2
KD_T925BTS_K_B5A-3880-00_EN_2nd Draft.indd 5KD_T925BTS_K_B5A-3880-00_EN_2nd Draft.indd 5 5/7/2021 10:55:01 AM5/7/2021 10:55:01 AM