Instruction Manual (Europe)

ENGLISH
39
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Part list for installation
(A) Trim plate (×1) (B) Mounting sleeve (×1)
(C) Wiring harness (×1) (D) Extraction key (×2)
(E) Flat head screw,
M5 × 8 mm (×8)
(F) Round head screw,
M5 × 8 mm (×8)
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2 Connect the wires properly.
See “Wiring connection” on page 40.
3 Install the unit to your car.
See “Installing the unit (in-dash mounting)”.
4 Connect the terminal of the car battery.
5 Press SOURCE B to turn on the power.
6 Reset the unit. (Page4)
Installation/Connection
Installing the unit (in-dash mounting)
Do the required wiring. (Page 40)
Dashboard of your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
Removing the unit
1 Fit the catch pin on the extraction keys into the
holes on both sides of the trim plate, then pull
it out.
2 Insert the extraction keys deeply into the slots
on each side, then follow the arrows as shown
below.
Installing the unit (without mounting
sleeve)
1 Remove the mounting sleeve and trim plate from the
unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with
screws (supplied).
Use only the specified screws. Using wrong screws might
damage the unit.
KW-DB95BT_E_B5A-3884-00_EN_1st Draft.indd 39KW-DB95BT_E_B5A-3884-00_EN_1st Draft.indd 39 17/8/2021 11:35:59 PM17/8/2021 11:35:59 PM