User manual

4
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
GETTING STARTED
Cancel the demonstration
When you turn on the power for the first time (or [ FACTORY RST ] is set to
[
YES ]), the display shows: “CANCEL DEMO” “PRESS” “VOLUME KNOB”
1 Press the volume knob.
[
YES ] is selected for the initial setup.
2 Press the volume knob again.
“DEMO OFF” appears.
Set the clock
1
Press and hold .
2 Turn the volume knob to select [ CLOCK ], then press the knob.
3 Turn the volume knob to select [ CLOCK SET ], then press the knob.
4 Turn the volume knob to make the settings, then press the knob.
Day
Hour Minute
5 Turn the volume knob to select [ 24H/ 12H ], then press the knob.
6 Turn the volume knob to select [ 12 HOUR ] or [ 24 HOUR ], then press the
knob.
7 Press to exit.
To return to the previous setting item, press .
1
2
Set the basic settings
1
Press and hold .
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press .
Default:
XX
SETTINGS
BEEP
(Not applicable when 3-way crossover is selected.)
ON :Activates the keypress tone.; OFF :Deactivates.
SRC SELECT
AM
*
1
ON :Enables AM in source selection.; OFF :Disables.
AUX *
1
ON :Enables AUX in source selection.; OFF :Disables.
F/W UPDATE
SYSTEM / DAB 1 *
2
/ DAB 2 *
2
F/W UP xxxx/
F/W UP xxxxx/
F/W UP Vxxx
YES :Starts upgrading the firmware.; NO :Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
FACTORY RST YES :Resets the settings to default (except the stored station).;
NO :Cancels.
*
1
Not displayed when the corresponding source is selected.
*
2
For KW-DB92BT .
3
JS_JVC_KW_R920BT_DB92BT_E_EN_3.indd 4JS_JVC_KW_R920BT_DB92BT_E_EN_3.indd 4 13/11/2015 4:25:27 PM13/11/2015 4:25:27 PM