Owner's Manual
Table Of Contents
ENGLISH
43
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Installing the unit (in-dash mounting)
Install onto the car brackets using the supplied screws
(B)
or
(C)
. The screw holes differ depending on the model of the cars.
Part list for installation
(A)
Wiring harness (×1)
(B)
Flat head screw, M5 × 8 mm (M5 × 3/8”) (×8)
(C)
Round head screw, M5 × 8 mm (M5 × 3/8”) (×8)
Basic procedure
1
Remove the key from the ignition switch, then disconnect
the
terminal of the car battery.
2
Connect the wires properly.
See “Wiring connection” on page 44.
3
Install the unit to your car.
See the following “Installing the unit (in-dash mounting)”.
4
Connect the terminal of the car battery.
5
Press SOURCE
B
to turn on the power.
6
Reset the unit. (Page4)
Use only the specified screws. Using wrong screws might damage the unit.
Installation/Connection
Do the required wiring. (Page 44)
Dashboard of
your car
Car bracket*
* Only for illustration purpose.
JS_JVC_KW_R940BTS_K_EN_6.indd 43JS_JVC_KW_R940BTS_K_EN_6.indd 43 10/4/2019 2:38:47 PM10/4/2019 2:38:47 PM