Owner's Manual

66
CONNECTION/INSTALLATION
R Installation procedure
1 To prevent a short circuit, remove the key
from the ignition and disconnect the
·
battery.
2 Make the proper input and output wire
connections for each unit.
3 Connect the speaker wires of the wiring
harness.
4 Connect the wiring harness wires in the
following order: ground, battery, ignition.
5 Connect the wiring harness connector to
the unit.
6 Install the unit in your car.
t Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (e.g., the sound may skip).
7 Reconnect the · battery.
8 Configure <Initial SETUP>. (Page4)
Installing the unit
R Installing the unit using the mounting
bracket removed from the car
Car Bracket
2 or 3
2 or 3
t Select the appropriate type of screw for the
mounting bracket: flat head (2) or round head
(3).