INSTRUCTIONS(Installation/IP Address Settings)

Installing the Camera on a
Desktop
0
Set
the
DIP switch prior to installing the camera.
0
Place the camera on a flat surface.
0
Be sure to place the base of the camera
horizontally. The camera will not operate
properly if it is slanted.
Memo :
0
The use
of ceiling mount bracket is not required.
Caution :
0
Do not move the camera while the power of the
system is on. Doing so may result in
malfunctions or accidents.
0
Do not
hold the camera head while carrying the
camera.
Connect the cables after these procedures.
Attaching the Camera to a
Tripod
0
Set
the
DIP switch prior to installing the camera.
0
Attach a tripod using the screw hole at the
bottom of this product.
(1/4-20UNC, ISO1222 (6.35 ㎜))
0
To prevent the camera recorder from falling off,
which may result in injuries or damages, read the
“INSTRUCTIONS” of the tripod to be used and
make sure that it is securely attached.
0
To ensure proper pan/tilt operation, set the
tripod such that the camera is parallel to the
horizontal surface.
Memo :
0
The use
of ceiling mount bracket is not required.
Caution :
0
If the camera recorder exceeds the weight limit
of the tripod, do not mount it on the tripod.
0
Use the tripod on a stable surface.
0
Use screws
with a screw length between 4.5 mm
and 7 mm.
0
Do not install the camera at a high location when
the camera is attached to a tripod.
Connect the cables after these procedures.
24
Installing the Camera on a Desktop
Installation/Connection