INSTRUCTIONS

DIP Switch Setting
Configure the DIP switch before installing this unit.
.
1
ON
2345678 1
ON
2345678
Switch Bit Function Description Remarks
Left 1 Select
communication
mode
For selecting a
communication mode.
OFF: LAN; ON: Serial
2 to 4 Select protocol For selecting protocols. Setting values when LAN is set:
0: JVC; 1: D star; 2: Standard; 3 to 7:
Reserved
Setting values when Serial is set:
0: Reserved; 1: D star; 2: Standard; 3 to
7: Reserved
* For
latest information on compatibility,
please visit our website.
5 to 7
Set camera address For selecting a camera
address.
Setting values when bit2 to bit 4 is set to
“Standard”:
0: AUTO; 1 to 7: Cameras 1 to 7
8
Baud rate For selecting a baud rate
for serial communication.
OFF: 9600 bps, ON: 38400 bps
Right 1 RS-232C,
RS-422/485
For selecting a
communication terminal
for serial communication.
OFF: RS-232C; ON: RS-422/485
2 Remote control
infrared output
For selecting an infrared
output.
OFF: No output; ON: Outputs IR_OUT
from RS-232C IN terminal Directing the
infrared remote control that comes with
commercially
available
controllers toward
the camera allows you to operate the
commercially available controller
(connected via RS-232C).
3 to 7 Service terminals Set them to OFF during
use.
-
8 RS-422/485
termination
RS-485 receiving end
110 Ω termination
OFF: Do not terminate; ON: Terminate
* Combination of bit and setting values of DIP switches 2 to 4 and 5 to 7
.
0
234
1
234
2
234
3
234
4
234
5
234
6
234
7
234
Setting Value (The following is for DIP switches 2 to 4. It is the same for DIP switches 5 to 7)
Bit
DIP Switch Setting
23
Getting Started