INSTRUCTIONS(Installation/IP Address Settings)

Infrared Remote Control
.
L
M
N
A
B
E
J
C
I
K
D
F
H
G
A
ZOOM button
Pressing the button at the T end moves the zoom lens
toward the telephoto range and the angle of view
becomes narrower.
Pressing the button at the W end moves the zoom
lens toward the wide-angle range and the angle of
view becomes wider.
B
AF button
Sets the camera to the Auto Focus mode.
C
Pan/Tilt, Menu operation button
Moves the display area.
Moves the cursor when the menu is displayed.
D
SET button
Restores the display area to the default position.
Functions as a confirmation button when the menu is
displayed.
E
MF, Cancel button
Sets the camera to the Manual Focus mode.
Functions as a cancel button when the menu is
displayed.
F
FAST button
Sets pan/tilt and zoom to high speed.
Short press
: High speed mode
Press and hold : Maximum speed mode
G
SLOW button
Sets pan/tilt and zoom to low speed.
Short press : Low speed mode
Press and hold
: Minimum speed mode
H
CAM1 to CAM3 buttons
Press and hold to select the camera to operate.
Memo :
0
Configure the IR ID setting in [Main Menu] B [System]
B [IR ID].
0
In the event that the [IR ID] setting is not consistent
with the selection of the CAM1 to CAM3 buttons, the
POWER lamp on the camera will appear blinking in
orange.
I
PRESET number button
Moves the display area to the recorded pan, tilt or
zoom position.
J
MENU button
Press and hold to open the menu for the camera unit.
K
PRESET button
To be used concurrently with the PRESET number
button.
Stores the current pan, tilt or zoom position in the
PRESET number.
L
ON/OFF button
Pressing and holding the button disables HDMI and
SDI output as well as operation from the remote
control unit.
Pressing and holding the ON/OFF button again
restores the camera to the camera mode.
M
FOCUS button
Use the F button to adjust focus toward the far end
and the N button to adjust toward the near end during
manual focus.
N
REC button
Saves recording to the microSD card on the camera
unit.
Pressing the button while recording is in progress
stops the recording.
Memo :
0
When using the remote control unit for the first time,
remove the battery insulation film before use.
0
The remote control unit uses one “CR2025” lithium
battery.
Make sure to load the battery in the correct +/-
orientation.
.
+ mark
Caution :
0
Do not place the remote control at a location that is
subject to high temperature. Otherwise, the remote
control may be deformed, thus resulting in
malfunction.
0
Place the batteries at a location that is out of reach of
children. In the event that the battery is swallowed by
mistake, consult a doctor immediately.
0
Do not throw the batteries into fire or place them at a
location that is subject to high temperature.
Otherwise, the batteries may explode.
0
When replacing the lithium battery, use one that is of
the same model or type. Using a different type of
battery may cause it to explode.
18
Names of Parts
Getting Started