INSTRUCTIONS

Noise Reduction
NR3D-Level
For configuring 3D noise reduction.
[Setting Values: Auto, Off, 1 to 11 (R6)]
Setup
Language
Switches between languages in the menu screen.
[Setting Values: REnglish, Français, Deutsch,
Italiano, Español, русский, 中文
, 日本語]
DVI Mode
For configuring the audio output from the HDMI
terminal.
HDMI :
Outputs the audio.
DVI : Mutes the audio.
[Setting Values: RHDMI, DVI]
Memo :
0
Press the
[HOME
] button to confirm the
selection and restart the camera.
SDI-3G Mode
For setting the 3G-SDI mapping structure.
[Setting Values: RLEVEL-A,LEVEL-B]
Video Output
For setting the terminal to output the video.
[Setting Values: RHDMI, SDI]
Memo :
0
Press the [HOME
] button to confirm the
selection and restart the camera.
Auto Inversion
For configuring the auto flip setting of the video
output.
On
:
Flips the video image when the camera
is mounted to the ceiling. Video is not
flipped when the camera is installed on
a desktop.
Off : Does not flip the video image when the
camera is mounted to the ceiling.
[Setting Values: ROn, Off]
Tally Mode
For configuring
whether to light up the tally lamp at
the front of the camera.
[Setting Values: ROn, Off]
Communication Setup
Protocol
For configuring the control protocols.
[Setting Values: RStandard, PELCO-D, PELCO-P,
Auto]
V_Address
For configuring the address of the Standard
protocol.
[Setting Values: 1 to 7 (R1)]
Memo :
0
This item can be configured when [Protocol] is
configured to “Standard” or “Auto
”.
V_AddrFix
For configuring the necessity of the Address Set
command.
On :
Address Set command is not needed.
Off : Address Set command is needed.
[Setting Values: ROff, On]
Memo :
0
This item can be configured when [Protocol] is
configured to “Standard
” or “Auto”.
Net Mode
For configuring the serial port network control.
[Setting Values: RSerial, Parallel]
Memo :
0
This item can be configured when [Protocol] is
configured to “Standard
” or “Auto”.
P_D_Address
For configuring the address of PELCO-D.
[Setting Values: 0 to 254 (R1)]
Memo :
0
This item can be configured when [Protocol] is
configured to “PELCO-D”
or “Auto”.
P_P_Address
For configuring the address of PELCO-P.
[Setting Values: 0 to 31 (R0)]
Memo :
0
This item can be configured when [Protocol] is
configured to “PELCO-P
” or “Auto”.
Baudrate
For configuring the baud rate of the serial port.
[Setting Values: 2400, 4800, R9600, 38400]
44
Noise Reduction
Menu Display and Detailed Settings