INSTRUCTIONS

Names of Parts
.
A
CBBDE
A
Tally lamp
Light
turns on or goes off during external control.
Turns on/off according to the menu setting and
blinks depending on the status of this camera.
B
Built-in microphone
You can configure the menu settings to make
use of the built-in microphone.
(A P34 [ Input Type ] )
C
STANDBY lamp
Lights up in green during standby.
D
Information display
Displays information on the camera settings.
E
POWER lamp
Lights up in blue when the power is turned on.
Terminal Section
.
BAC KJD EF IGH
A
RESTORE switch (Reset switch)
Memo :
0
Press and hold down to activate reset.
B
HDMI terminal
C
3G-SDI terminal
D
LINE IN terminal
E
RS485 terminal
0
Half duplex mode
0
Baud rate:
2400/4800/9600/38400 bps
0
Start position: 1 bit
0
Data bit length: 8 bits
0
Stop bit length: 1 bit
0
Check digit: None
F
USB 2.0 terminal
G
RS232 OUT terminal
H
RS232 IN terminal
RS232 communication control
The serial port parameters are as follows.
0
Half duplex mode
0
Baud rate:
2400/4800/9600/38400 bps
0
Start position: 1 bit
0
Data bit length: 8 bits
0
Stop bit length: 1 bit
0
Check digit: None
.
12
543
678
RS-232C IN RS-232C OUT
Pin
Number
Signal
Name
Pin
Number
Signal Name
1 DTR_IN 1 DTR_OUT
2 DSR_IN 2 DSR_OUT
3 TXD_IN 3 TXD_OUT
4 GND 4 GND
5 RXD_IN 5 RXD_OUT
6 GND 6 GND
7 IR_OUT 7 NC
8 NC 8 NC
Names of Parts
17
Getting Started