Operation Manual

English - 8 -
Viewing the Connections -
Side Connectors
CI Slot is used for 1.
inserting a CI card. A
CI card allows you to
view all the channels
that you subscribe to.
For more information,
see “Conditional
Access” section.
Component Video 2.
Inputs (YPbPr) are
used for connecting
component video.
You can connect the
component video
and audio sockets
with a device that
has component
output. Connect the
component video
cables between the
COMPONENT VIDEO
INPUTS on on the
TV and the component video outputs of your
device. While connecting, be sure that the
letters on your TV, “Y”, “Pb”, “Pr” correspond
with your device’s connectors.
IMPORTANT:Please do not connect a device to
PC socket while using YPbPr input.
Video Input 3. (INPUT FAV) is used for connecting
video signals of external devices.Connect the
video cable between the VIDEO IN socket
on the
TV and the VIDEO OUT jack on your
device.
Audio Inputs 4. (INPUT FAV) are used for
connecting audio signals of external devices.
Connect the audio cable between the
AUDIO
INPUTS on the TV and the AUDIO OUTPUT
jacks on your device.
Also to enable PC/YPbPr sound connection
in such a case, use an appropriate audio cable
between the connected device’s audio outputs
and the TV’s audio inputs
Note: If you connect a device to the TV via the
VIDEO or PC/YPbPr cable you should also
connect your device with an audio cable to the
AUDIO INPUTS of the TV to enable audio.
Headphone jack is used for connecting an 5.
external headphone to the system. Connect to
the HEADPHONE jack to listen to the TV from
headphones.
Standby switch is used for turning the TV on 6.
or of
f.
INPUT AV
Using the Cable Holder
You can use the supplied cable holder as the
following:
• Place the cable holder into the cable holder hole
located on the rear side of the TV as illustrated
above.
• Place cables into the cable holder after all necessary
connections are made.
Power Connection
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the
ambient room temperature before you connect the
set to the mains.
• Plug the power cable to the mains socket outlet.
Aerial Connection
• Connect the aerial or cable TV plug to the AERIAL
INPUT socket located at the rear of the TV.
SPDIF
SCART
VGA
Coax.OUT
HDMI 2
HDMI 1
A01_[GB]_MB45M_26741W_(RM-C2503-1C_UK)_IDTV_NICKEL13_10067199_50162791.indd 8A01_[GB]_MB45M_26741W_(RM-C2503-1C_UK)_IDTV_NICKEL13_10067199_50162791.indd 8 08.04.2010 08:47:2708.04.2010 08:47:27