Operation Manual

Menu Functions

INSTALLATION menu

e-shift

Switches the display resolution.

• Off: Switches to 2K resolution.

Picture Mode will automatically be set to fixed mode.

• On (recommended): Switches to 4K resolution.

Submenu Functions and Descriptions

Projector Mode

See "Choosing a location" for details.

Test Pattern

Is used to adjust the image size and focus

and check that the projected image is free

from distortion. To close the test pattern,

go back to this menu and select Off.

Lamp Settings

• Lamp Mode

Select the projector lamp power from the following modes.

• Normal: Provides full lamp brightness.

• Eco: Reduces system noise and lamp power consumption by 30%.

If the Eco mode is selected, the light output will be reduced and result in darker

projected pictures. See "Setting Lamp Mode"

for details.

• Reset Lamp Timer

Activate this function only after a new lamp is installed. When you select Reset,

a "Reset Successfully" message displays to notify that the lamp time has

been reset to "0".

• Lamp Information

Select to learn the duration (in hours) of lamp usage which is automatically

calculated by the built-in timer.

12V Trigger

There is one 12V trigger that works according to your needs for installation

scenarios. Two selections are available:

• Off: If this is selected, the projector will not send electronic signal out

when it is turned on.

• On: The projector will send a low to high electronic signal out when it is

turned on, a high to low signal out when it is turned off.

Submenu Functions and Descriptions