OperationManual
Table Of Contents
- Getting Started
- Set up
- Operate
- Adjust/Set
- Adjusting the Image Quality
- Adjusting the Output Value of the Projected Image (Gamma)
- Fine-tuning to the Preferred Gamma Setting
- Reducing the After-image of Fast-moving Images (Blur Reduction)
- Adjusting the Contrast (Lens Aperture)
- Correcting Uneven Illumination (Uniformity Correction)
- Adjustments and Settings in the Menu
- Other Adjustments and Settings
- Maintenance
- Troubleshooting
- Others
Viewing Videos
1
Turn on the power
Press the C [ON] button
2
Select the image to project
Press the [INPUT] button
0
Play back the selected device to project the image.
To hide the image temporarily
Press the [HIDE] button
0
Press the [HIDE] button again to resume display of the image.
0
The power cannot be turned off when the image is temporarily hidden.
3
Turn off the power
Press the B [STAND BY] button
0
While the
“Are you sure you want to turn off?” message is displayed,
press the B [STAND BY] button again.
CAUTION
0
The power cannot be turned off within approximately 60 seconds after it
has been turned on.
0
After the
light goes off, the fan will run for about 100 seconds to cool down
the lamp (Cool-down mode). Do not disconnect the power cable while
cooling is in progress.
0
The power cannot be turned on again while cooling is in progress (100
seconds).
0
Pull out the power plug when the unit is not to be used for a prolonged
period of time.
INPUT INFO. HIDE
LENS
CONTROL
LENS
MEMORY
RGB
SOLO
DIM.
BRIGHTNESS
CONTRAST
COLOR
1
2
3
18
Operate