OperationManual
Table Of Contents
- Getting Started
- Set up
- Operate
- Adjust/Set
- Adjusting the Image Quality
- Adjusting the Output Value of the Projected Image (Gamma)
- Fine-tuning to the Preferred Gamma Setting
- Reducing the After-image of Fast-moving Images (Blur Reduction)
- Adjusting the Contrast (Lens Aperture)
- Correcting Uneven Illumination (Uniformity Correction)
- Adjustments and Settings in the Menu
- Other Adjustments and Settings
- Maintenance
- Troubleshooting
- Others
Mounting/Dismounting the Screen
The screen that comes with the main unit can be replaced with an optional screen.
Refer to the catalog for the types of optional screens available.
CAUTION
0
Before replacing the screen, be sure to turn off the power or press the [HIDE] button on the remote control to hide the
image.
0
When dismounting the screen, take care not to touch the parts inside the main unit such as the mirror. This could cause
significant deterioration in the performance of the equipment.
0
Hold at the frame when carrying the screen. Avoid touching the screen surface. Failure to do so may cause the screen to
become dirty.
0
Avoid applying pressure to the screen. Failure to do so may result in deformation and damage.
Mounting the Screen
1
Insert the two pins inside the top surface of the screen frame into the holes on the top
surface of the frame of the main unit
A
Place the top edge of the screen frame on the top of the main unit.
B
Bring the bending area inside the screen frame to the front side of the frame of the main unit.
0
Do not place on top of the main unit.
C
Insert the pin of the screen frame into the hole on the top surface of the frame of the main unit. (Both sides)
.
C
A
B
Bending Area
Main Unit - Top Surface of Frame
Screen Frame
(Same for both sides)
2
Insert the two pins on the inner side of the bottom of the screen frame into the holes on
the lower frame plate of the main unit
0
Insert the pins by pushing the lower side of the screen frame.
0
Mount in such a way that the light shielding sponges affixed on the side panels of the main unit are on the inside of
the screen frame.
0
Make sure the screen frame is fully inserted and fitted. (Both sides)
.
Light Shielding
Sponge
Main Unit -
Lower Frame
Plate
Screen
Frame
(Same for both sides)
45
Maintenance