JLIP Video Capture Docking Station Instructions Manual
EN 65
TROUBLESHOOTING
Error
–
–
This application will
close.
Check devices
–
–
Confirm
that power is ON.
No devices detected to
connect.
Power ON all devices in
system.
Communication error
(&H
(number))
Check cable connection.
Select the device to control.
No video cassette!!
Load a video cassette to ID
(number).
Invalid entry in scene
(number) (There is IN > OUT
condition). Correct the time
or delete the scene.
Select a number between 0
and 24.
Invalid frame number on drop
frame counter.
v The COM port used for the JLIP connector is not
selected, or the COM port is selected but the
connection is wrong.
m Check the connected COM port and select it on the
"Serial Port Selection" screen (Z pg. 46).
v Power is not supplied or the connection is wrong.
m Connect the devices correctly and turn them on
(
Z pg. 42, 43).
v Device is not turned on or cable is disconnected.
m Connect the device correctly and turn it on
(
Z pg. 42, 43).
m If device was turned off and on again during
operation, click "OK". All devices should function
properly.
v The line where the name of the device to use
appears is not clicked.
m Click on it and "OK" (Z pg. 47).
v The video cassette is not loaded in the camcorder.
When the video cassette is removed during
operation, this message appears.
m Insert the video cassette into the camcorder.
v The value of the CUT OUT point is smaller than
the CUT IN point's.
m Set the value of the CUT OUT point so that it is
larger than the CUT IN point's (Z pg. 50, 54).
v When correcting the CUT IN/OUT points, the
value you set differs from the original by over 25
frames.
m Select integral number from 0 to 24 (Z pg. 54).
v Because the DV-format digital camcorder uses the
drop frame system, inputting frame 00 and 01 is
impossible.
m Input frame value other than 00 or 01
(
Z pg. 48, 54).
MESSAGE
v POSSIBLE CAUSE
m CORRECTIVE ACTION
The monitor displays of the application software illustrated in this manual may differ from
those you are actually viewing depending on the operating environment of your computer.