DEUTSCH ENGLISH MC-D207U INSTRUCTIONS For Customer Use: Enter below the Model No. and Serial No. which are located at the top of the unit. Retain this information for future reference. Model No. MC-D207U Serial No. This instruction manual has been manufactured from 100% recycled paper.
Thank you for purchasing the JVC MC-D207U DVD-ROM DRIVE. Before you start operating this unit, please read the instructions carefully in order to obtain the best possible performance. 1. DANGER: Invisivle laser radiation will occur when the unit is open with a failed or defeated interlock. 2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel.
䡵 ROM Replacement When this drive is mounted in the MC-1200U/1600U or MC-2200U/2600U CD-ROM Library, certain serial numbers may require to replace the ROM. Read the section “ROM REPLACEMENT IN THE CD-ROM LIBRARY” on page 6 for the first time. ACCESSORIES AND DOCUMENTATION Accessories Drive locking screw (M3 with washer) ......................... 2 (including one spare) Documentation Instructions ..............................................................
INSTALLATION 2. How to Open the Drive Storage Cover 䡵 Please also refer to the corresponding sections in the Library instructions. 1. Remove the screws from the drive section cover, which is located at the rear of the Library. 2. Remove the drive storage cover. Drive No.6 • Figure shows the MC-2200U or MC-8200U Drive No.5 Drive No.4 Drive storage section Drive No.3 Drive No.2 Drive No.
INSTALLATION 5. How To Connect Cables To The DVD-ROM Drive 䡵 Connect to the drive the power supply cable and control cable which extend from the side of the DVD-ROM drive installation slot. 䡵 With the MC-2100U and the MC-8100U models be sure to connect a control cable with the same component No., as the drive bay No., otherwise proper operation may not be possible. 䡵 Insert all connectors firmly.
INSTALLATION 2. ID2 - ID0 : This sets the SCSI ID No. on the drives. Switch SCSI ID No. ID2 ID1 ID0 0 OFF OFF OFF 1 OFF OFF ON 2 OFF ON OFF 3 OFF ON ON 4 ON OFF OFF 5 ON OFF ON 6 ON ON OFF 7 ON ON ON Remarks Default factory setting 䡵 Set the SCSI ID No. between 0 - 7 using only an ID No. that is not being used by other SCSI devices. 䡵 For the details on default factory settings, please refer to the section “SCSI ID No.
ROM REPLACEMENT IN THE CD-ROM LIBRARY If the DVD-ROM drive is being mounted in a MC-2200U/2200PU/2600U/2600PU or MC-1200U/1600U CD-ROM Library and does not meet the following conditions, the ROM is required to be replaced in the Library. Please consult your dealer or nearest JVC-authorized service agent for ROM replacement. 䡵 The library already has a MC-D207U mounted within the unit. 䡵 The library already has a MC-D104U or a MC-R18U drive mounted within the unit.
MC-D207U DVD-ROM DRIVE VICTOR COMPANY OF JAPAN, LIMITED is a registered Trademark owned by VICTOR COMPANY OF JAPAN, LTD. is a registered Trademark in JAPAN, the U.S.A., the U.K. and many other countries.