cover_UX-PN7[J].fm Page 1 Tuesday, April 15, 2008 1:57 PM COMPACT COMPONENT SYSTEM NX-PN7 For customer use: Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. INSTRUCTIONS Model No. Serial No.
safety_UX-PN7[J].fm Page 1 Thursday, March 20, 2008 9:28 AM Warnings, Cautions and Others Mises en garde, précautions et indications diverses CAUTION The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
safety_UX-PN7[J].fm Page 2 Thursday, March 20, 2008 9:28 AM Note to CATV system installer: This reminder is provided to call the CATV system installer’s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. For U.S.A.
safety_UX-PN7[J].fm Page 3 Thursday, March 20, 2008 9:28 AM Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1. Front: No obstructions and open spacing. 2. Sides/Top/Back: No obstructions should be placed in the areas shown by the dimensions below. 3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm (3-15/16") or more.
NX-PN7[J].BOOK Page 1 Friday, April 18, 2008 3:53 PM Contents Introduction................................................. 2 Precautions ................................................................ 2 Getting Started ............................................ 3 Connections................................................................ 4 Canceling the Display Demonstration ....................... 5 Basic Operations ......................................... 6 Main Unit ..............................
NX-PN7[J].BOOK Page 2 Friday, April 18, 2008 3:53 PM Introduction Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. Precautions Installation • Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C (41°F and 95°F). • Install the unit in a location with adequate ventilation to prevent internal heat buildup inside the unit.
NX-PN7[J].BOOK Page 3 Friday, April 18, 2008 3:53 PM Getting Started In this manual, operations using the remote control are mainly explained; however, you can use the buttons and controls on the unit if they have the same (or similar) name and marks. Supplied Accessories After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied.
NX-PN7[J].BOOK Page 4 Friday, April 18, 2008 3:53 PM Connections Do not connect the AC power cord until all other connections have been made. Connecting the Antennas FM antenna (supplied): Extend it so that you can obtain the best reception. To connect the AM loop antenna Left side AM loop antenna (supplied): Turn it until the best reception is obtained. For better FM reception Disconnect the supplied FM antenna, and connect to an outdoor FM antenna using a 75 Ω wire with coaxial type connector.
NX-PN7[J].BOOK Page 5 Friday, April 18, 2008 3:53 PM Connecting the Video Cord to View a Video/Picture from iPod When viewing a video/picture from your iPod on your TV, use a composite video cord (not supplied) to connect the VIDEO OUT jack on the unit and the composite video input on your TV. Video cord (not supplied) Right side Connecting the Power Cord To a wall outlet Plug in the AC power cord only after all connections are complete.
NX-PN7[J].BOOK Page 6 Friday, April 18, 2008 3:53 PM Basic Operations Main Unit Dock A (P.12) Illumination bars (P.10) Dock B (P.12) Display (P.7) STANDBY lamp Remote control sensor Operating on the Main Unit Buttons Functions Turns on or off (standby) the power. Changes the color of the illumination bars. (P.10) • For DEMO button, see page 5. Activates Sound Turbo. (P.10) Changes the source to FM, AM (P.15), or AUDIO IN (P.17).
NX-PN7[J].BOOK Page 7 Friday, April 18, 2008 3:53 PM Buttons Functions • Changes the source to iPod /iPod . (P.13) • Starts playback and pauses for iPod. (P.13) • iPod (P.13): Press: Reverse skip/forward skip Hold down: Reverse search/forward search • FM/AM (P.15): Tunes in to a station. Adjusts the volume level (VOL MIN/VOL 1 to VOL 29/VOL MAX). Display Information Symbols Description iPod Lights up when an iPod is connected to dock A. iPod Lights up when an iPod is connected to dock B. S.
NX-PN7[J].BOOK Page 8 Friday, April 18, 2008 3:53 PM Using Headphones Be sure to turn down the volume before connecting headphones. • Connecting headphones will deactivate the speakers. Stereo mini plug Headphones (not supplied) Right side Remote Control P.9 P.10 P.18 – 20 P.13, P.18, P.20 P.14 P.13, P.15, P.16, P.18 – 20 P.13, P.15, P.16 P.14, P.15 P.14, P.16 – 20 P.10 P.10 , P.10 P.10 Operating on the Remote Control Basic operations Buttons Main functions Turns on or off (standby) the power.
NX-PN7[J].BOOK Page 9 Friday, April 18, 2008 3:53 PM Buttons Main functions Changes the display information. • For iPod A/iPod B/AUDIO IN: Source name Clock Day of the week • When the unit is turned off: Clock Day of the week • For FM/AM: Frequency Clock Day of the week • Changes the source to iPod /iPod . (P.13) • Starts playback and pauses for iPod. (P.13) Changes the source to FM, AM (P.15, P.16), or AUDIO IN (P.17). Adjusts the volume level (VOL MIN/VOL 1 to VOL 29/VOL MAX).
NX-PN7[J].BOOK Page 10 Friday, April 18, 2008 3:53 PM To change the color of the illumination bars You can change the color of the illumination bars. • The color is memorized for each source. Press repeatedly to change the color of the illumination bars. • You can select one of the nine colors. • When the source is iPod or iPod the bar below the source iPod.
NX-PN7[J].BOOK Page 11 Friday, April 18, 2008 3:53 PM Playing Back from iPod You can connect 2 iPod devices to the unit and enjoy sound and video from the iPod.
NX-PN7[J].BOOK Page 12 Friday, April 18, 2008 3:53 PM Connecting iPod Devices Connect the iPod to dock A or B on the unit. You can have 2 iPod devices connected at the same time. • Make sure the unit is on standby when you connect an iPod. Dock adapter (supplied with the iPod or sold separately) Dock A Dock B To detach the dock adapter from the dock: Pull up the dock adapter with your fingernail or a sharp pointed tool using the slot.
NX-PN7[J].BOOK Page 13 Friday, April 18, 2008 3:53 PM Operations For details, refer also to the instruction manual for iPod. NOTES: • Before viewing a video/picture from your iPod on your TV, make the appropriate video setting on the iPod. For details of the setting, see the instruction manual for iPod.
NX-PN7[J].BOOK Page 14 Friday, April 18, 2008 3:53 PM Buttons On the Unit Functions On the remote Confirms an item on the menu/screen. — * Control of the iPod Center button* — Select the desired shuffle mode. “SHUFFLE” appears on the display for a while. • The shuffle icon lights up on the display/screen of the iPod. • To cancel, press again until the shuffle icon disappears. • Shuffle play applies to the iPod selected as the source. — — Select the desired repeat mode.
NX-PN7[J].BOOK Page 15 Friday, April 18, 2008 3:53 PM Listening to FM/AM Broadcasts Basic Operations Buttons Functions On the Unit On the remote Selects FM or AM as the source. FM AM AUDIO IN When an FM programme is broadcast in stereo, ST (stereo) lights up on the display (only when the reception is good). Press: Changes the frequency. Hold down and release: The unit starts searching for stations and stops when a station of sufficient signal strength is found. • To stop searching, press again.
NX-PN7[J].BOOK Page 16 Friday, April 18, 2008 3:53 PM Presetting Stations You can preset 30 FM stations and 15 AM stations. 1 Select FM or AM as the source. 2 Tune in to the station you want to preset. • You can also store the monaural reception mode for FM preset stations if selected. 3 Activate the preset number entry mode. “SET” flashes on the display for a few seconds. • Finish the following operations while the indication is flashing. Select a preset number for the station you want to store.
NX-PN7[J].BOOK Page 17 Friday, April 18, 2008 3:53 PM Playing Back from Other Equipment Connecting Other Equipment By using a stereo mini plug cord (not supplied), you can connect other equipment with analog audio output jacks, such as a portable audio player, etc. Stereo mini plug cord (not supplied) Portable audio device Right side • Refer to the instruction manual supplied with the equipment. NOTE: Make sure the unit is on standby when connecting or disconnecting other equipment.
NX-PN7[J].BOOK Page 18 Friday, April 18, 2008 3:53 PM Setting the Clock and Timer Setting the Clock Set the built-in clock before using the Timer. • You can set the clock when the unit is turned on or on standby 1 Activate the clock setting mode. “AdjCLOCK” appears then the hour digit of the time indication flashes on the display. • If you have already adjusted the clock before, press the button 2 times to activate the clock setting mode.
NX-PN7[J].BOOK Page 19 Friday, April 18, 2008 3:53 PM Setting the Timer Using the Timer, you can wake up with music, etc. • When using an iPod or other equipment as the playback source, connect it to the unit beforehand. (P.12, P.17) • You can set the Timer when the unit is turned on or on standby. • The unit is turned off automatically 2 hours after it is turned on by the Timer. 1 Activate the timer setting mode. “TIMER 1,” “TIMER 2,” or “TIMER 3” appears on the display.
NX-PN7[J].BOOK Page 20 Friday, April 18, 2008 3:53 PM 5 6 1 Adjust the hour then the minute for the on-time. 2 Select a playback source—“IPod A,” “IPod B,” “FM,” “AM,” or “AUDIO IN.” • When “FM” or “AM” is selected, select the preset number of the station you want to use. When you select “FM --” or “AM --,” the preset station you last tuned in is set. (See “Listening to FM/AM Broadcasts” on page 15.) 3 Select the volume level.
NX-PN7[J].BOOK Page 21 Friday, April 18, 2008 3:53 PM Troubleshooting If you are having a problem with your unit, check this list for a possible solution before calling for service. General Power does not come on. The power plug is not inserted securely. Plug it in securely. (P.5) Adjustments or settings are suddenly cancelled before you finish. There is a time limit. Repeat the procedure again. Operations are disabled. The built-in microprocessor may malfunction due to external electrical interference.
NX-PN7[J].BOOK Page 22 Friday, April 18, 2008 3:53 PM Specifications Accessories Tuner See page 3. FM tuning range: 87.5 MHz – 108.0 MHz (100 kHz channel space) AM tuning range: 530 kHz – 1710 kHz (10 kHz channel space) Amplifier Output Power – without iPod 7.5 W per channel, min. RMS, driven into 8 Ω at 1 kHz, with no more than 10% total harmonic distortion – with an iPod 7.0 W per channel, min. RMS, driven into 8 Ω at 1 kHz, with no more than 10% total harmonic distortion – with two iPod devices 6.
warranty_UX-PN7[J].
warranty_UX-PN7[J].
cover_UX-PN7[J].