Operation Manual

13
Basic operations
On the remote control:
Press one of the source selecting
buttons (DVD 3, USB MEMORY 3,
FM/AM or TV SOUND).
DVD 3: To play back a disc (DVD VIDEO, VCD, etc.).
(See page 16.)
USB MEMORY 3: To play back a file on a USB mass storage
class device. (See page 16.)
FM/AM: To tune in an FM or AM (MW) station. (See page
35.)
Each time you press the button, the band alternates between
FM and AM (MW).
TV SOUND: To select the TV connected to the AV OUT
(SCART) connector.
• Some TVs cannot emit sound signals. In this case, you
cannot listen to the TV sound through the system. (See
page 10.)
On the center unit:
Press SOURCE repeatedly until the
source name you want appears on
the display window.
NOTE
• When a source except DVD or USB MEMORY is selected,
this system does not output video signals.
• It may take time to change the source.
CAUTION
• Always set the volume to the minimum level before starting
any source. If the volume is set at a high level, the sudden
blast of sound could permanently damage your hearing and/
or blow out the speakers.
On the remote control:
Press AUDIO VOL +/–.
On the center unit:
Press VOLUME +/–.
CAUTION
Be sure to turn down the volume:
• Before connecting or putting on headphones as high volume
may damage both the headphones and your hearing.
• Before disconnecting headphones as high volume may
suddenly be emitted from the speakers.
While connecting a pair of headphones to the PHONES
jack on the center unit, the system automatically cancels the
surround mode (see page 20) currently selected, deactivates
the speakers, and activates the headphone mode.
“H.PHONE” appears on the display window.
Headphone mode
When using the headphones, the following signals are
emitted regardless of your speaker settings:
• For 2 channel sources, the front left and right channel
signals are emitted through the headphones.
• Multi-channel signals are down-mixed and emitted
through the headphones.
Press MUTING.
To restore the sound
Perform one of the following:
•Press MUTING again.
•Press AUDIO VOL +/– (or VOLUME +/– on the center
unit).
Press DIMMER while holding SHIFT.
Each time you repeat the procedure, you can change the
brightness level in 3 steps.
Selecting the source to play
Adjusting the volume
[VOLUME]
Listening with headphones
(not supplied)
Turning off the sound
temporarily [MUTING]
Adjusting the brightness of
the indications [DIMMER]
See page 12 for button locations.
EN_TH-U1[B]-03body.fm Page 13 Wednesday, July 25, 2007 4:06 PM