UX-G30[B].
UX-G30[B].book Page 1 Tuesday, February 14, 2006 5:00 PM Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. 1. CLASS 1 LASER PRODUCT 2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel. 3. CAUTION: Visible and/or invisible class 1M laser radiation when open. Do not view directly with optical instruments. DO NOT cut off the mains plug from this equipment.
UX-G30[B].book Page 2 Wednesday, December 28, 2005 5:04 PM Information for Users on Disposal of Old Equipment [European Union] This symbol indicates that the electrical and electronic equipment should not be disposed as general household waste at its end-of-life. Instead, the product should be handed over to the applicable collection point for the recycling of electrical and electronic equipment for proper treatment, recovery and recycling in accordance with your national legislation.
UX-G30[B].book Page 1 Wednesday, December 28, 2005 5:04 PM Introduction Precautions How to Read This Manual Installation • Button and control operations are explained in the table below. • Some related tips and notes are explained later in the sections “Learning More about This System” and “Troubleshooting,” but not in the same section explaining the operations ( indicates that the content has some information).
UX-G30[B].book Page 2 Wednesday, December 28, 2005 5:04 PM Contents Introduction ............................................................... 1 Connections ................................................................ 3 Before Operating the System.................................... 6 Daily Operations—Playback .................................... 7 Listening to the Radio .................................................................. 8 Playing Back a Disc ..........................................
UX-G30[B].book Page 3 Wednesday, December 28, 2005 5:04 PM Connections Supplied accessories After unpacking, check to be sure that you have all the following items: • FM antenna (1) • Remote control (1) • AM loop antenna (1) • Batteries (2) If any item is missing, consult your dealer immediately. Do not connect the AC power cord until all other connections have been made. Rear view 1 From AM/FM antenna See page 4. 2 From the speakers See page 5.
UX-G30[B].book Page 4 Wednesday, December 28, 2005 5:04 PM 1 AM/FM antenna For the better AM/FM reception To assemble the AM loop antenna Outdoor FM antenna (not supplied) To connect the AM loop antenna FM antenna (supplied) Extend it so that you can obtain the best reception. AM loop antenna (supplied) Keep it connected. Vinyl-covered wire (not supplied) Extend it horizontally. AM loop antenna (supplied) Turn it until the best reception is obtained.
UX-G30[B].book Page 5 Tuesday, February 14, 2006 5:00 PM 2 Speakers To connect a portable audio device To connect the speaker cords Make sure that both speakers are connected correctly and firmly. 1 Hold 2 Insert 3 Release AUX jack DOWN PHONES UP AUX Stereo mini plug cord (not supplied) Portable audio device Red From left speaker Black From right speaker Red • When connecting the speaker cords, match the polarity of the speaker terminals: red cord to (+) and black cord to (–).
UX-G30[B].book Page 6 Wednesday, December 28, 2005 5:04 PM Before Operating the System The indications on the display tell you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 1 2 3 6 4 5 PRGM RND TA NEWS INFO FM AM ST MONO 1 MP 3 S.TURBO AHB PRO A.STBY QP Link SLEEP 123 p 7 8 9 Indications on the main display • While listening to radio: • While selecting AUX: FM S.TURBO S.
UX-G30[B].book Page 7 Wednesday, December 28, 2005 5:04 PM Daily Operations—Playback In this manual, the operations using the remote control are explained mainly; however, you can use the buttons and controls on the main unit if they have the same (or similar) name and symbol. 1 SET CANCEL QP LINK DIMMER 2 PTY SEARCH 7 4,¢ PRESET/GROUP/PTY DOWN,UP NUMBER SELECT FM MODE/ PLAY MODE 3 1 Turn on the power. The STANDBY lamp on the main unit turns off. Without pressing STANDBY/ON ...
UX-G30[B].book Page 8 Wednesday, December 28, 2005 5:04 PM 3 Select a preset number for the station you store. Listening to the Radio PRESET/GROUP/PTY UP DOWN To select the band (FM or AM) Remote control: SET Increases the preset numbers. Main unit: FM FM/AM AM Decreases the preset numbers. FM FM S.TURBO S.TURBO QP Link QP Link To tune in to a station While FM or AM is selected... Remote control: To tune in to a preset station Main unit: 2 sec.
UX-G30[B].book Page 9 Wednesday, December 28, 2005 5:04 PM To select a track Increases the track numbers. Decreases the track numbers. To select a group (MP3 only) 1 While disc play is stopped, activate the group select mode. PTY SEARCH Track select mode MP 3 S.TURBO QP Link Group select mode MP 3 S.TURBO QP Link 2 Select a group number. To select track numbers on an MP3 disc, enter the number in three digits. Refer to the following examples: When selecting track 24...
UX-G30[B].book Page 10 Wednesday, December 28, 2005 5:04 PM Daily Operations—Sound&Other Adjustments To drop the volume in a moment Remote control FADE MUTING SLEEP A. STANDBY CLOCK/ TIMER DIMMER Remote ONLY To restore the volume, press again, or adjust the volume level. SET Adjusting the Sound CANCEL To emphasize the sound—Sound Turbo This function emphasizes the sound.
UX-G30[B].book Page 11 Wednesday, December 28, 2005 5:04 PM 2 Changing the Display Brightness PRESET/GROUP/PTY UP DOWN You can dim the display window. DIMMER DIM 1 Adjust the hour, then the minute. SET DIM 2 DIM OFF (Initial setting) Now the built-in clock starts working. DIM 1 Dims the display and the illumination on the main unit. DIM 2 Dims the display more than DIM 1 and turns off the illumination on the main unit.
UX-G30[B].book Page 12 Wednesday, December 28, 2005 5:04 PM Advanced Radio Operations Searching for a Program by PTY Codes Remote control Remote ONLY You can locate a particular kind of program from the preset channels (see page 8) by specifying the PTY codes. To search for a program using the PTY codes PTY SEARCH 7 PRESET/GROUP/PTY DOWN,UP DISPLAY MODE 1 While listening to an FM station... PTY SEARCH FM ST FM ST S.TURBO QP Link REPEAT/ TA/News/Info S.
UX-G30[B].book Page 13 Wednesday, December 28, 2005 5:04 PM Switching Temporarily to a Program of Your Choice Automatically NEWS: AFFAIRS: Remote ONLY The Enhanced Other Networks function allows the System to switch temporarily to a preset FM station broadcasting a program of your choice (TA, NEWS, or INFO). • This function works while listening to an FM station providing the required signals. While listening to an FM station, select the program type.
UX-G30[B].book Page 14 Wednesday, December 28, 2005 5:04 PM Advanced Disc Operations 2 Remote control Select track numbers you want for Program Play. PRESET/GROUP/PTY UP DOWN SET Increases the track numbers. SET Decreases the track numbers. CANCEL • For regular CDs CD 6 4,¢ PRESET/GROUP/PTY DOWN,UP REPEAT/ TA/News/Info Main unit CD ‹/8 0 Programming the Playing Order— Program Play S.TURBO PRGM MP 3 S.
UX-G30[B].book Page 15 Wednesday, December 28, 2005 5:04 PM To exit from Program Play Playing Repeatedly—Repeat Play Before playback or while playback is stopped... Remote ONLY You can repeat playback. FM MODE/ PLAY MODE PROGRAM RANDOM Canceled While a regular CD is loaded... REPEAT TA/News/Info REP TRK • Exiting from Program Play erases the stored program. REP ALL REP OFF (Canceled) While an MP3 disc is loaded...
UX-G30[B].book Page 16 Wednesday, December 28, 2005 5:04 PM Timer Operations 1 Remote control Select one of the timer setting modes you want to set— Daily 1 ON time, Daily 2 ON time, or Daily 3 ON time. STANDBY/ON CLOCK/ TIMER SET CLOCK/ TIMER Daily Timer 1 Daily Timer 2 Daily Timer 3 DAILY 1 ON (Time) DAILY 2 ON (Time) DAILY 3 ON (Time) Canceled Clock setting (see page 11) CANCEL S.TURBO 1 QP Link Ex.
UX-G30[B].book Page 17 Tuesday, February 14, 2006 5:00 PM 3 Turn off the unit (on standby) if you have set the ontime. To turn off the Timer after its setting is done Since Daily Timer is activated at the same time everyday, you may need to cancel it on some particular days. STANDBY/ON 1 Select the Timer you want to cancel.
UX-G30[B].book Page 18 Tuesday, February 14, 2006 5:00 PM Additional Information Learning More about This System Daily Operations—Playback (see pages 7 to 9) Listening to the Radio: • If you store a new station into an occupied preset number, the previously stored station in that number will be erased. • When you unplug the AC power cord or if a power failure occurs, the preset stations will be erased in a few days. If this happens, preset the stations again.
UX-G30[B].book Page 19 Tuesday, February 14, 2006 5:00 PM Timer Operations (see pages 16 and 17) • When you unplug the AC power cord or if a power failure occurs, the timer will be canceled. You need to set the clock first, then the timer again. Maintenance To get the best performance of the System, keep your discs, and mechanism clean. Handling discs Troubleshooting If you are having a problem with your System, check this list for a possible solution before calling for service.
UX-G30[B].book Page 20 Wednesday, December 28, 2005 5:04 PM Specifications Parts Index Amplifier section Refer to the pages to see how to use the buttons and controls. Output Power: 60 W (30 W + 30 W) at 6 Ω (10% THD) Speakers/Impedance: 6 Ω – 16 Ω Audio Input AUX: 500 mV/50 kΩ (at “AUX LVL 1”) 250 mV/50 kΩ (at “AUX LVL 2”) 125 mV/50 kΩ (at “AUX LVL 3”) Remote control STANDBY/ON Tuner section FM tuning range: 87.50 MHz – 108.
UX-G30[B].book Page 1 Wednesday, December 28, 2005 5:04 PM SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured.