Operating instructions
Table Of Contents
- Introduction
- Installation and Connection
- System Example
- About Connection Cables
- The right sequence to connect and set the camera
- Setting the switches
- Mounting the base
- Cable Connection
- Mounting the camera unit
- Adjusting the video image
- Mounting the inner dome
- Mounting the dome cover
- Mounting the camera using the electrical box
- Mounting the camera using the pipe
- White-spot correction
- Others
22
Installation and Connection
1.Connecting the coaxial cable (A Pg. 17)
Lower the protection cover and connect the
connectors. Upon connecting, cover the
connectors using the protection cover.
2.Connecting the AC 24 V/DC 12 V power
supply wires
Note:
● To mount a heater (sold separately) to this
unit, make sure to connect it to an AC 24 V
supply during use.
3.Connect the alarm cable.
(TK-C215VP12U/E only)(A Pg. 18)
4.Binding the AC 24 V/DC 12 V power
supply wires and alarm signal wires (TK-
C215VP12U/E only) with insulating tape
Make sure to bind the connecting portions of AC
24 V/DC 12 V power supply wires and alarm
signal wires (TK-C215VP12U/E only) with
insulating tape.
5.Wrap insulation tape around cables.
6.Storing cables
Upon connecting, push the connector into the
cable storage space of the camera unit.
Note:
● When mounting the camera to the electrical
box, push the connector into the electrical
box.
● While the camera unit is disconnected from
the base, be extremely careful not to drop the
camera unit.
S
]
Cable Connection
1
3
2
4
Coaxial Cable
Protection Cover
Solder or Caulk
Insulating Tape
Bind
insulating
tape
AC 24 V/DC 12 V
Power Supply
Wire
Cable Storage
Space
*TK-C215VP12U/E is used in the above illustration
Alarm signal Wire
(TK-C215VP12 only)
TK-C215VP4_JP.book Page 22 Thursday, November 2, 2006 10:51 AM