English COVER_UX-G200[J].FM Page 1 Wednesday, November 5, 2008 3:08 PM MICRO COMPONENT SYSTEM UX-G200 —Consists of CA-UXG200 and SP-UXG200 INSTRUCTIONS For Customer Use: Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. Model No. Serial No.
SAFETY_UX-G200[J].FM Page 1 Wednesday, November 5, 2008 3:07 PM Warnings, Cautions and Others Mises en garde, précautions et indications diverses CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
SAFETY_UX-G200[J].FM Page 2 Wednesday, November 5, 2008 3:07 PM CAUTION Battery shall not be exposed to excessive heat such as sunshine, fire or the like. ATTENTION Les piles ne doivent en aucun cas être exposées à une chaleur excessive (lumière du soleil, feu, etc.). CAUTION The button in any position does not disconnect the mains line. Disconnect the mains plug to shut the power off completely (the STANDBY lamp goes off).
UX-G200[J].BOOK Page 1 Tuesday, December 2, 2008 3:05 PM Introduction Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. Others • Should any metallic object or liquid fall into the System, unplug the AC power cord and consult your dealer before operating any further. DO NOT disassemble the System since there are no user serviceable parts inside.
UX-G200[J].BOOK Page 2 Tuesday, December 2, 2008 3:05 PM Contents Getting Started ...................................................3 Step 1: Unpack ................................................................... 3 Step 2: Prepare the Remote Control .................................. 3 Step 3: Hook Up ................................................................ 4 Before Operating the System ............................6 Daily Operations—Playback ............................
UX-G200[J].BOOK Page 3 Tuesday, December 2, 2008 3:05 PM Getting Started Step 1:Unpack the package and check the accessories. Step 1: Unpack After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately.
UX-G200[J].BOOK Page 4 Tuesday, December 2, 2008 3:05 PM Step 3: Hook Up If you need more detailed information, see page 5. Turn the power off to all components before connections. FM antenna (supplied) Extend it so that you can obtain the best reception. Right speaker AM loop antenna (supplied) Turn it until the best reception is obtained. Main unit Left speaker Red To a wall outlet Plug the AC power cord only after all connections are complete.
UX-G200[J].BOOK Page 5 Tuesday, December 2, 2008 3:05 PM To connect the AM loop antenna To connect the speaker cords Make sure to connect the wire correctly. Make sure the both speakers are connected correctly and firmly. 1. Hold 3. Lock 2. Insert 2. Insert 3. Release For better FM/AM reception Outdoor FM antenna (not supplied) Disconnect the supplied FM antenna, and connect to an outdoor FM antenna using a 75 Ω wire with coaxial type connector.
UX-G200[J].BOOK Page 6 Tuesday, December 2, 2008 3:05 PM Before Operating the System The indications on the display teach you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 1 2 3 4 5 6 7 8 9 10 REPEAT1 GROUP RANDOM PROG.
UX-G200[J].BOOK Page 7 Tuesday, December 2, 2008 3:05 PM Daily Operations—Playback 1 Turn on the power. The STANDBY lamp on the main unit turns off. 2 Select the source. Playback automatically starts if the selected source is ready to start. • If you select AUDIO IN, start playback source on the external component. Number buttons DISPLAY/ PROGRAM PRESET 1,y, 4,x TUNING/ GROUP K,5 3 Adjust the volume. 4 Operate the target source as explained later.
UX-G200[J].BOOK Page 8 Tuesday, December 2, 2008 3:05 PM To preset the stations Listening to the Radio You can preset 20 FM and 10 AM stations. To select the band (FM or AM) 1 2 From the remote control: FM/AM/ AUDIO IN FM FM MONO A_IN AM Tune in to a station you want to preset. Activate the preset number entry mode. DISPLAY/ PROGRAM (AUDIO IN) kHz MHz On the main unit: FM FM MONO AM • Finish the following process while the indication on the display is flashing.
UX-G200[J].BOOK Page 9 Tuesday, December 2, 2008 3:05 PM Playable Media and Files Playing Back a USB Mass Storage Class Device This System can play back following types of discs/files. • Audio CD • MP3/WMA files on a CD-R, CD-RW, or USB mass storage class device You can connect a USB mass storage class device such as a USB flash memory device, Digital Audio Player (DAP) to this System. Audio CD CD-R CD-RW • This System may not play back some files even though their formats are listed above.
UX-G200[J].BOOK Page 10 Tuesday, December 2, 2008 3:05 PM To display ID3/WMA tag information Playing Back Discs/Files While playing MP3/WMA... To select a track/group DISPLAY/ PROGRAM To select a track: ID3 ON ID3 OFF PRESET Selects the next tracks. ID3/WMA tag information is shown on the display. Playing Back Other Equipment Selects the previous tracks.
UX-G200[J].BOOK Page 11 Tuesday, December 2, 2008 3:05 PM Daily Operations—Sound & Other Adjustments Adjusting the Volume Remote control You can adjust the volume level from level 0 (“VOL MIN”) to level 31 (“VOL MAX”). Remote control: Main unit: CLOCK/ SLEEP VOLUME Remote ONLY To drop the volume in a moment FADE MUTING To restore the volume, press again, or adjust the volume level.
UX-G200[J].BOOK Page 12 Tuesday, December 2, 2008 3:05 PM Setting the Clock Turning Off the Power Automatically Set the clock before using the Daily Timer (see page 16). • You can set the clock only when the System is turned off (on standby). —Sleep Timer 1 1 Activate the sleep timer mode. 2 sec. Turn off (standby) the System. CLOCK/ SLEEP SLEEP 2 Activate the clock setting mode. 2 sec. CLOCK/ SLEEP REPEAT1 GROUP TRACK WMA 2 Specify the shut-off time (in minutes).
UX-G200[J].BOOK Page 13 Tuesday, December 2, 2008 3:05 PM Advanced Disc/USB Mass Storage Class Device Operations Programming the Playing Order— Remote control Program Play You can arrange the playing order of the tracks (up to 32) before you start playback. • You can repeat the programmed tracks by pressing REPEAT. Number buttons CD 6 4, x TUNING/ GROUP K, 5 RANDOM DISPLAY/ PROGRAM 1 Select the source. USB MEMORY CD USB MEMORY 6 STOP 7 STOP or 2 Before starting playback, activate Program Play.
UX-G200[J].BOOK Page 14 Tuesday, December 2, 2008 3:05 PM (2) Select a track. To check the programmed contents While the PROG. indicator lights up on the display and playback is stopped... PRESET DISPLAY/ PROGRAM PROG. MP3 CD To modify the program Track number 4 While the PROG. indicator lights up on the display and playback is stopped... Confirm the selection. DISPLAY/ PROGRAM Edit: 1 Press DISPLAY/PROGRAM repeatedly until the program step you want to edit is displayed.
UX-G200[J].BOOK Page 15 Tuesday, December 2, 2008 3:05 PM Playing at Random—Random Play Remote ONLY Playing Repeatedly—Repeat Play You can play back all the tracks at random. You can play back tracks repeatedly. 1 For audio CD: Select the source. USB MEMORY CD STOP REPEAT REPEAT1 or Remote ONLY REPEAT Canceled (No indication) 2 For MP3/WMA: Start Random Play. REPEAT RANDOM REPEAT1 Canceled REPEAT REPEAT GROUP (No indication)* Playback starts in the random order.
UX-G200[J].BOOK Page 16 Tuesday, December 2, 2008 3:05 PM Daily Timer Operations Setting the Daily Timer Remote control Using the Daily Timer, you can wake up with music, etc. • Set the clock before setting the Daily Timer. (See page 12.) • To exit from the timer setting, press STOP 7 as required. TIMER 1 Activate the Daily Timer setting. 2 sec. TIMER USB MEMORY 6 CD 6 4, x FM/AM/ AUDIO IN STOP 7 TIMER 2 Set the On Time. (1) Set the hour.
UX-G200[J].BOOK Page 17 Tuesday, December 2, 2008 3:05 PM 6 (2) Set the hour. PRESET Turn off the System. TIMER To deactivate the Daily Timer When the System is turned on... (3) Set the minutes as the hour setting above. You cannot set On time and Off time on the same time setting. 4 Select the playback source. (1) Proceed to the playback source setting. TIMER (2) Select the playback source; “CD,” “USB,” or “TUNER”.
UX-G200[J].BOOK Page 18 Tuesday, December 2, 2008 3:05 PM Additional Information Learning More about This System Daily Operations—Playback (see pages 7 to 10) Listening to the Radio: • If you store a new station into an occupied preset number, the previously stored station in that number will be erased. • When you unplug the AC power cord or if a power failure occurs, the preset stations will be erased in a few days. If this happens, preset the stations again.
UX-G200[J].BOOK Page 19 Tuesday, December 2, 2008 3:05 PM Daily Operations—Sound & Other Adjustments Troubleshooting (see pages 11 and 12) Adjusting the Volume: If you are having a problem with your System, check this list for a possible solution before calling for service. • Be sure to turn down the volume before connecting or putting the headphones. General: • This function also affects the sound through the headphones. Adjustments or settings are suddenly canceled before you finish.
UX-G200[J].BOOK Page 20 Tuesday, December 2, 2008 3:05 PM Disc Operations: The disc does not play. ] The disc is placed upside down. Place the disc with the label side up. The disc sound is discontinuous. ] The disc is scratched or dirty. Daily Timer Operations: The Daily Timer does not work. ] The System has been turned on when the on-time comes. The Daily Timer starts working only when the System is turned off. ] There might have been a power failure. Set the clock first, then the timer again.
UX-G200[J].BOOK Page 21 Tuesday, December 2, 2008 3:05 PM General Specifications Power requirement: Power consumption: Amplifier section Output Power: Speakers/Impedance: 8 W per channel, min. RMS, driven into 4 Ω at 1 kHz with no more than 10% total harmonic distortion. 4Ω–8Ω Terminals Dimensions (approx.): Mass (approx.): AC 120 V , 60 Hz 35 W (at operation) 1.1 W (on standby) 144 mm × 218 mm × 256 mm (5-11/16 inches × 8-5/8 inches × 10-1/8 inches) (W × H × D) 2.3 kg (5.
UX-G200[J].BOOK Page 22 Tuesday, December 2, 2008 3:05 PM Parts Index Refer to the pages to see how to use the buttons and controls.
warranty_UX-G200[J].fm Page 1 Friday, November 21, 2008 3:02 PM TO OUR VALUED CUSTOMER THANK YOU FOR PURCHASING THIS JVC PRODUCT. WE WANT TO HELP YOU ACHIEVE A PERFECT EXPERIENCE. NEED HELP ON HOW TO HOOK UP? NEED ASSISTANCE ON HOW TO OPERATE? NEED TO LOCATE A JVC SERVICE CENTER? LIKE TO PURCHASE ACCESSORIES? IS HERE TO HELP! TOLL FREE: 1(800)252-5722 http://www.jvc.com Remember to retain your Bill of Sale for Warranty Service.
warranty_UX-G200[J].fm Page 2 Friday, November 21, 2008 3:02 PM LIMITED WARRANTY 1-1 USA ONLY ONLY FOR PRODUCT PURCHASED IN U.S.A. JVC Americas Corp. (JVC) warrants this product and all parts thereof, except as set forth below ONLY TO THE ORIGINAL RETAIL PURCHASER to be FREE FROM DEFECTIVE MATERIALS AND WORKMANSHIP from the date of original purchase for the period shown below.
COVER_UX-G200[J].