Operation Manual
22
TEST: Broadcasts for testing emergency broadcast
equipment or unit
ALARM: Emergency announcement
NONE: No program type, undefi ned program, or
difficult to categorize into particular types
Advanced Disc/USB mass storage class device
(see pages 16 to 18)
Programming the Playing Order—Program Play:
• If you try to program a 33rd track, “FULL” appears on the
display.
• While programming steps...
Your entry will be ignored if you have tried to program an item
number that does not exist on the disc (for example, selecting
track 14 on a disc that only has 12 tracks).
Timer Operations (see pages 19 and 20)
• When you unplug the AC power cord or if a power failure
occurs, the timer will be canceled. You need to set the clock
first, then the timer again.
• You can not set On time and Off time on the same time setting.
Troubleshooting
If you are having a problem with your System, check this list
for a possible solution before calling for service.
General:
Adjustments or settings are suddenly canceled before
you finish.
] There is a time limit. Repeat the procedure again.
Operations are disabled.
] The built-in microprocessor may malfunction due to
external electrical interference. Unplug the AC power cord
and then plug it back in.
Unable to operate the System from the remote control.
] The path between the remote control and the remote sensor
on the System is blocked.
] Point it at the remote sensor on the front panel.
] Signals cannot reach the remote sensor.
Move closer to the System.
] The batteries are exhausted.
No sound is heard from the speakers.
] Speaker connections are incorrect or loose (see page 6).
] Headphones are connected (see page 8).
Radio Operations:
Hard to listen to broadcasts because of noise (see pages 4
to 6).
] Antennas connections are incorrect or loose.
] The AM loop antenna is too close to the System.
] The FM antenna is not properly extended and positioned.
Disc Operations:
The disc does not play.
] The disc is placed upside down. Place the disc with the label
side up.
The disc sound is discontinuous.
] The disc is scratched or dirty.
Timer Operations:
Daily Timer does not work.
] The System has been turned on when the on-time comes.
Timer starts working only when the System is turned off.
] There might have been a power failure. Set the clock first,
then the timer again.
“INVALID” is indicated on the display.
] Set the Off Time first (see page 20).
Maintenance
To get the best performance of the System, keep your discs,
and mechanism clean.
Handling discs
• When removing the disc from its case, hold it at the edge while
pressing the center hole lightly.
• Do not touch the shiny surface of the disc, or bend the disc.
• Put the disc back in its case after use to prevent warping.
• Be careful not to scratch the surface of the disc.
• Avoid exposure to direct sunlight, temperature extremes, and
moisture.
To clean the disc:
Wipe the disc with a soft cloth in a straight line from center to
edge.
Body.fm Page 22 Monday, May 21, 2007 11:45 AM