English COVER.
SAFETY.FM Page 1 Thursday, April 19, 2007 11:38 AM Warnings, Cautions and Others CAUTION To reduce the risk of electrical shocks, fire, etc.: 1 Do not remove screws, covers or cabinet. 2 Do not expose this appliance to rain or moisture. CAUTION • Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.) • Do not place any naked flame sources, such as lighted candles, on the apparatus.
SAFETY.FM Page 2 Thursday, April 19, 2007 11:38 AM Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1. Front: No obstructions and open spacing. 2. Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more.
SAFETY.FM Page 3 Thursday, April 19, 2007 11:38 AM IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted.
SAFETY.FM Page 4 Thursday, April 19, 2007 11:38 AM SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment.
UX-S15[B].BOOK Page 1 Monday, May 21, 2007 10:30 AM Contents Introduction ........................................................2 Precautions ......................................................................... 2 How to Read This Manual ................................................. 3 Getting Started ...................................................4 Step 1: Unpack ................................................................... 4 Step 2: Prepare the Remote Control .........................
UX-S15[B].BOOK Page 2 Monday, May 21, 2007 10:30 AM Introduction Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. Precautions Installation • Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C. • Install the System in a location with adequate ventilation to prevent internal heat buildup inside the System.
UX-S15[B].BOOK Page 3 Monday, May 21, 2007 10:30 AM How to Read This Manual To make this manual as simple and easy-to-understand as possible, we have adapted the following methods: • Button and control operations are explained as listed in the table below. In this manual, the operations using the remote control is mainly explained; however, you can use the buttons and controls on the main unit if they have the same (or similar) name and marks.
UX-S15[B].BOOK Page 4 Monday, May 21, 2007 10:30 AM Getting Started Step 1: Unpack Step 1:Unpack the package and check the accessories. After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately.
UX-S15[B].BOOK Page 5 Monday, May 21, 2007 10:30 AM Step 3: Hook Up If you need more detailed information, see page 6. Turn the power off to all components before connections. FM antenna (supplied) Extend it so that you can obtain the best reception. AM loop antenna (supplied) Turn it until the best reception is obtained. Red Black To a wall outlet Plug the AC power cord only after all connections are complete.
UX-S15[B].BOOK Page 6 Monday, May 21, 2007 10:30 AM To connect the AM loop antenna To connect the speaker cords Make sure to connect the wire correctly. Make sure the both speakers are connected correctly and firmly. 1 Hold 1 Unlock 2 Insert 3 Release 3 Lock 2 Insert For better FM/AM reception Outdoor FM antenna (not supplied) Disconnect the supplied FM antenna, and connect to an outdoor FM antenna using a 75 Ω wire with coaxial type connector (IEC or DIN45325).
Body.fm Page 7 Thursday, July 5, 2007 4:52 PM Before Operating the System The indications on the display teach you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 1 2 3 4 5 6 7 8 9 REPEAT1 GROUP RANDOM PROG. TRACK WMA MP3 CD 10 NEWS INFO TAPE REC kHz MHz SLEEP HBS JAZZ ROCK POP CLASSIC ST MONO 11 12 13 14 15 16 Indications on the main display • While listening to radio: PROG.
UX-S15[B].BOOK Page 8 Monday, May 21, 2007 10:30 AM Daily Operations—Playback 1 Turn on the power. 1 The STANDBY lamp on the main unit turns off. 2 Select the source. Playback automatically starts if the selected source is ready to start. • If you press TAPE, only the source will be selected. Numeric buttons DISPLAY/ PROGRAM 4/1/ Á/¢ PRESET 2 STOP 7 TUNING/ GROUP/PTY 3 Adjust the volume. 4 Operate the target source as explained later.
UX-S15[B].BOOK Page 9 Monday, May 21, 2007 10:30 AM To preset the stations Listening to the Radio You can preset 20 FM and 10 AM stations. To select the band (FM or AM) FM/AM FM FM MONO 1 2 Tune in to a station you want to preset. Activate the preset number entry mode. DISPLAY/ PROGRAM AM PROG. kHz MHz You can also carry out the same operation using the FM/AM on the System. • Finish the following process while the indication on the display is flashing.
UX-S15[B].BOOK Page 10 Monday, May 21, 2007 10:30 AM To locate a track directly and start play Playing Back a Disc Remote ONLY How to Select Numbers, see page 8. To insert a disc Main Unit ONLY You can insert discs while playing another source. • When you play MP3/WMA disc, the selectable tracks by using numeric keys are limited to a current group. To display ID3 tag While playing MP3/WMA disc.
UX-S15[B].BOOK Page 11 Monday, May 21, 2007 10:30 AM Daily Operations—Sound & Other Adjustments Adjusting the Volume Remote control You can adjust the volume level from level 0 (VOL MIN) to level 31 (VOL MAX). Remote control: Main unit: CLOCK/ SLEEP VOLUME VOLUME Remote ONLY To drop the volume in a moment FADE MUTING 4/¢ To restore the volume, press again, or adjust the volume level.
Body.fm Page 12 Thursday, July 5, 2007 4:52 PM Setting the Clock Turning Off the Power Automatically Without setting the built-in clock, you cannot use the Daily Timer (see page 20). To turn off the System after a certain period of time—Sleep Timer 1 1 Turn off (standby) Activate the sleep timer mode. 2 sec. CLOCK/ SLEEP 2 Activate the clock setting mode. 5 sec. CLOCK/ SLEEP 2 REPEAT1 GROUP TRACK WMA Specify the time (in minutes). SLEEP Adjust the hour.
UX-S15[B].BOOK Page 13 Monday, May 21, 2007 10:30 AM Advanced Radio Operations To show the Radio Data System information While listening to an FM station... Remote control DISPLAY MODE PS PTY RT Station Frequency TUNING/ GROUP/PTY PS Station names is displayed. “NO PS” will appear if no signal is sent. PTY The broadcast program type is displayed. “NO PTY” will appear if no signal is sent. RT Text messages the station sends is displayed. “NO RT” will appear if no signal is sent.
UX-S15[B].BOOK Page 14 Monday, May 21, 2007 10:30 AM 3 Start searching. 26; 5-)4+0 How the Enhanced Other Networks function actually works: CD CASE 1 The receiver searches 20 preset FM stations, stops when it finds the one you have selected, and tunes in to that station. • If no program is found, “NO FOUND” appear on the display. • To stop searching any time during search, press PTY SEARCH.
UX-S15[B].BOOK Page 15 Monday, May 21, 2007 10:30 AM Advanced Disc Operations Programming the Playing Order— Remote control Program Play You can arrange the playing order of the tracks (up to 32) before you start playback. • You can repeat one programmed track or all the programmed tracks by pressing REPEAT. 1 Numeric buttons CD 6 4/¢ DISPLAY/ PROGRAM Before starting playback, press DISPLAY/ PROGRAM. For CD DISPLAY/ PROGRAM PROG. TRACK CD STOP 7 For MP3/WMA disc TUNING/ GROUP/PTY PROG.
UX-S15[B].BOOK Page 16 Monday, May 21, 2007 10:30 AM 4 Start playback. Playing at Random—Random Play Remote ONLY CD You can play back all the tracks on the disc at random. 1 The tracks you have selected are played back in the order you have programmed. To skip a track: To pause: Press RANDOM. RANDOM To stop: CD STOP To release, press again. • Tracks cannot be selected with the Numeric buttons during Program Play. To check the programmed contents While the PROG.
UX-S15[B].BOOK Page 17 Monday, May 21, 2007 10:30 AM Playing Repeatedly—Repeat Play Remote ONLY You can repeat playback. For CD: During Random Play: REPEAT REPEAT1 REPEAT Canceled (No indication) For MP3/WMA disc: REPEAT REPEAT1 Canceled REPEAT REPEAT GROUP (No indication) REPEAT1 Repeats the current track. REPEAT GROUP Repeats all the tracks in the current group. REPEAT Repeats all the tracks. Repeats the program.
Body.fm Page 18 Monday, June 11, 2007 4:47 PM Advanced Tape Operations IMPORTANT Remote control It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video recording, broadcast or cable program and in any literary, dramatic musical, or artistic work embodied therein. Recording on a Tape TAPE 6 CD 6 FM/AM You can use type I tapes for recording. • To play a tape, see page 10.
UX-S15[B].BOOK Page 19 Monday, May 21, 2007 10:30 AM Synchronized Disc Recording You can start and stop both disc playback and tape recording at the same time. To record the entire disc 1 Load a disc and insert a recordable cassette. • If the current playing source is not the CD player, press CD 6, then 7. To record Program Play or Random Play Select Program Play (and make a program: see page 15) or Random Play (see page 16). 2 Start recording.
UX-S15[B].BOOK Page 20 Monday, May 21, 2007 10:30 AM Timer Operations Setting the Timer Remote control Using Timer, you can wake up with music, etc. • You can set the Timer when the System turns on. • To exit from the timer setting, press 7 as required. TIMER How Daily Timer actually works TAPE 6 CD 6 4/¢ Once the Daily Timer has been set, the timer ( ) indicator is lit on the display. Lights TIMER lamp on the main unit.
UX-S15[B].BOOK Page 21 Monday, May 21, 2007 10:30 AM 3 To inactivate the TIMER. Set Off Time 1 Set Off Time setting. When the System turns on. TIMER TIMER 2 Set time. See the step 2 1, 2 You can not set On time and Off time on the same time setting. 4 Select the playback source. 1 Select the source. • When setting both SLEEP TIMER and DAILY TIMER, the timer which turns the unit off earlier takes precedence. TIMER 2 Select the playback source; “CD”, “TAPE” or “TUNER”.
UX-S15[B].BOOK Page 22 Monday, May 21, 2007 10:30 AM Additional Information Playing Back a Tape: Learning More about This System Daily Operations—Playback (see pages 8 to 10) Listening to the Radio: • If you store a new station into an occupied preset number, the previously stored station in that number will be erased. • When you unplug the AC power cord or if a power failure occurs, the preset stations will be erased in a few days. If this happens, preset the stations again.
UX-S15[B].BOOK Page 23 Monday, May 21, 2007 10:30 AM NATION M: Current popular music from another nation region, in that country’s language OLDIES: Classic pop music FOLK M: Folk music DOCUMENT: Programs dealing with factual matters, presented in an investigative style TEST: Broadcasts for testing emergency broadcast equipment or unit ALARM: Emergency announcement NONE: No program type, undefined program, or difficult to categorize into particular types Operations are disabled.
UX-S15[B].BOOK Page 24 Monday, May 21, 2007 10:30 AM Maintenance Specifications To get the best performance of the System, keep your discs, and mechanism clean. Amplifier section Output Power: Handling discs • When removing the disc from its case, hold it at the edge while pressing the center hole lightly. • Do not touch the shiny surface of the disc, or bend the disc. • Put the disc back in its case after use to prevent warping. • Be careful not to scratch the surface of the disc.
UX-S15[B].BOOK Page 25 Monday, May 21, 2007 10:30 AM Parts Index Refer to the pages to see how to use the buttons and controls.
UX-S15[B].
COVER.
