User Guide

ENGLISH
E-21
4.Connect the LAN cable. (A Pg. 26)
5.Connect the power cable and the alarm
cable. (A Pg. 24)
Memo :
● The power cable must not be connected
when PoE is used.
6.Wind the waterproof tape. (A Pg. 26)
䡵 Mounting
1.Align the secured outer case with the
position alignment mark of the camera.
N
o
t
e :
● Make sure that the cables are not caught in
the outer case.
2.Turn the camera in the clockwise
direction.
T Check that the ○ mark can be seen. (Refer
to the diagram below)
3.Tighten the Camera Fastening Screws
and secure the camera.
䡵 Image adjustment
When the camera is mounted, adjust the image
settings while looking at the actual image.
(A Pg.27 AImage adjustmentB)
䡵 Mounting the Dome Cover
After the image adjustment is completed, mount
the dome cover.
Installation is complete when the dome cover is
mounted.
(A Pg.29 AMounting the Dome CoverB)
FRONT
UP
3
2
1
Towards
fastening
hook
From the
ceiling slab
Towards the shooting
direction
T Loosen
sufficiently
Fall-prevention
wire
(not supplied)
Outer case
mounting screw
Less than 3 mm
4
5
6
Solder or crimp
Insulation tape
Wind the waterproof
tape.
3
2
1
Position
alignment
mark
Camera
Fastening
Screw
T Check
VN-C215_EN.book Page 21 Tuesday, March 20, 2007 1:54 PM