User Guide

114
Settings and operation of Built-in Viewer
Auto Pan Setting (continued)
PTZ Controller Operation
(continued)
C
A
B
E
D
Select the [Mode] of the Auto Pan operation.
Right : This rotates the camera horizontally in the
right direction from the [Start Position].
Left : This rotates the camera horizontally in the left
direction from the [Start Position].
Return:Moves toward the [Return Position] from the
[Start Position] in a clockwise direction, and
moves to and fro between the [Start Position]
and [Return Position].
Unless the restrictions below are applicable,
you can specify any position as the Start
Position and Return Position.
● When tilt angle is 90 degrees or higher:
An error message appears when the tilt
angle is set to 90 degrees or higher.
● Electronic zoom area:
When electronic zoom is used, the
maximum optical zoom ratio is specified.
M
emo:
● If the zoom ratios of the [Start Position] and
[Return Position] are different, Zoom and
Pan/Tilt movements may not be uniform.
Click the [Auto Pan] tab to display the [Auto Pan]
screen.
Select the [Start Position] and [Return Position]
(only during AReturnB) of the operation.
Operate the camera manually, decide on a position
and click [Apply] to register.
Click [Go To] to move the camera to the registered
position.
M
emo:
● For details on the manual operation, see
[Operation] ( A Page 106).
Click [Apply] to complete the Auto Pan setting.
Select the Auto Pan operation speed.
[Setting values : Low, Middle, High]