User Guide

16
Connection/Installation
Setting Up the Wall
1 Make holes in the wall
Make holes (R 45 mm) for the connecting cables
to pass through.
Note：
● Check the strength of the wall. A less firm wall
may cause the unit to fall.
2 Install the anchor bolts for mounting
the camera
Install 4 anchor bolts (M8 ⳯ 35 mm and above)
to mount the camera.
3 Install the anchor bolt for mounting
the fall prevention wire
Install the anchor bolt (M8 ⳯ 35 mm and above)
to mount the fall prevention wire 30 mm below
the center of the upper two anchor bolts that are
used to mount the camera.
4 Pull the cables from the hole in the
wall
Pull the power cable, LAN cable and alarm
signal cable from the wall.
Setting Up the Camera
1 Remove the dome cover
Loosen the screws (x4) and remove the dome
cover from the camera.
Mounting the Camera
Be sure to put on protective glasses to protect
your eyes from falling objects when mounting
the camera.
213
176
60
20
152
126
63
45
12
30
1
2
3
Anchor bolts to
mount the camera
Anchor bolt to
mount the fall
prevention wire
Alarm signal cable
Power cable
LAN Cable
Dome Cover