Users Manual

门
—
，
2).Power on CPE , all indicator lights on panel are on one time, later the
power indicator light is on, WIFI indicator light is on, the device starts
up completely
3). Connect the Ethernet cable to the ETH1 port and the indicator light
of ETH1 is on. Make sure the Ethernet can connect with network
successfully
4).Connect the terminal device with the CPE _WIFI , the WIFI indicator
light blinks. The device connection is successful that indicates that
the network is connected
4. Settings of connection with internet by 3G/4G
network:
CAUTION: Place the CPE in a horizontal position to avoid damage
from shaking or dropping
1). Insert a standard SIM card as below picture showing
13
P,c4, SIM card ,nstal lat,on
2). Unpack and connect the power adapter that in the package with the
CPE power connector
3). Power on CPE , all indicator lights on panel are on one time, later the
power indicato 「 light is on, WIFI indicator light is on, the device
sta 「 ts up completely
4).The device automatically dials up, the panel NET indicator light ,s
on, then the indicator light flashes to indicate that the device dials
successfully and the CPE device has successfully connected to the
base station network
/
4