KV50 Vyper KV50 USER’S MANUAL English 1 REV.
KV50 CONTENTS 2 SYMBOLS 3 1. INTRODUCTION 4 2. APPLICATIONS 4 3. KEY FEATURES 4 4. UNPACKING 5 5. WARRANTY 5 6. SAFETY 5 7. PHYSICAL 6 8. REAR PANEL 7 9. SERVICE 8 10. SPECIFICATIONS 9 REV.
KV50 SYMBOLS K-array declares that this device is in compliance with applicable CE standards and regulations. Before putting the device into operation, please observe the respective country-specific regulations! WEEE Please dispose of this product at the end of its operational lifetime by bringing it to your local collection point or recycling center for such equipment. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature.
KV50 1. INTRODUCTION Vyper KV50 is an ultra-flat passive speaker system comprised of eight 1” neodymium magnet transducers housed in an elegant and sturdy aluminum chassis. The eight closely spaced cone drivers provide true line array characteristics - phase coherence, low distortion and focused listening in both the near field and at a distance from the speaker. A steel bracket accessory provides an ease to mount wall application for permanent installations.
KV50 4. UNPACKING Each K-array loudspeaker is built to the highest standard and thoroughly inspected before leaving the factory. Upon arrival, carefully inspect the shipping carton, then examine and test your new loudspeaker. If you find any damage, immediately notify the shipping company. Only the consignee may institute a claim procedure regarding the system’s electronic equipment. 5.
KV50 7. PHYSICAL 20 cm 7.87” 3.6 cm 1.42” 3.6 cm 1.42” 2 cm 0.79” 50 cm 19.7” weight: 0.7 kg (1.54 lb) 6 REV.
KV50 8. REAR PANEL 1) Mounting M5 screw holes. Most K-array mounting or flying accessories are designed to screw into the speakers using these holes. The KV50 is equipped with two screw holes. 2) Impedance switch (16 Ω or 64 Ω). Selects the impedance of the speaker. Please refer to your amplifier’s specifications to select the correct speaker impedance for your configuration. 1 7 2 REV.
KV50 9. SERVICE To obtain service: 1) Contact the official K-array distributor in your country. Your local distributor will direct you to the appropriate service center. 2) If you are calling for service, please have the serial number(s) of the unit(s) available for reference. Ask for Customer Service, and be prepared to describe the problem clearly and completely. 3) If the problem cannot be resolved over the phone, you may be required to send the unit in for service.
KV50 10. SPECIFICATIONS TECHNICAL DATA KV50 Acoustics Power handling 150 w (AES) Max Power 300 w 1 Impedance 16Ω or 64Ω (selectable) Frequency range 200 Hz - 20 KHz.
KV50 The contents of this manual are furnished for informational purposes only. Hp Sound Equipment s.r.l. assumes no responsibility for any errors or inaccuracies that may appear in this manual. Hp Sound Equipment s.r.l. reserves the right to make modifications without prior notice.
K-array s.r.l. unipersonale Via Paolina Romagnoli - 50037 San Piero a Sieve (Firenze) - Italy tel. +39 055 8487222 - fax. +39 0558487238 e-mail: info@k-array.com www.k-array.
