User's Manual

With the Access Control enabled, you can authorize wireless units to access the Access Point
by identifying the MAC address of the wireless devices that are allowed access to transmit
data. Further more, the Bandwidth control function allows you to control the
upstream/downstream bandwidth per client basis. Note that, only when the MAC addresses of
the wireless stations are in the Access Control Table, they will be able to access network via
Access Point. To create or edit the Access Control Table, do the following:
Ø Go to the Access Control tab and check “Enable Access Control”.
Ø Click the “Add” button and enter the MAC addresses of the wireless stations you allow
to access.
Ø Set “Up bandwidth”, “Down bandwidth” and “Total bandwidth” if needed. Specify the
desired bandwidth or unlimited if you do not need the bandwidth control.
Ø Click “Apply” to make the setting take effect.
You can also configure the Access Control by using web-based management.
NOTE: Be aware that, when you enable the Access Control Table without any MAC address
in the table, no access is allowed to communicate with the Access Point.
Use the following buttons to manage the Access Control Table:
Add – to enter MAC addresses of authorized wireless devices one at a time.
Edit – to change the entries in the table if you enter the incorrect MAC address.
Remove – to remove MAC addresses one at a time.
Clear – to remove all MAC addresses in the table.
Import – to import an existing Access Control Table.
Export – to save the current Access Control Table to a location on your computer. You may
save the file as a text document.
Advanced Security