User manual

3 Description
 6-digit 14-segment LED display, 14 mm

Help Text display
 Preset counter with two relay outputs
 Preset entry via the front keys or via the Teach-In
function
 Step or tracking preset
 Pulse counter, Frequency meter, Timer or Hour
meter
 Preset-, Batch- or Total counter
 Set function for pulse counter and timer
 Multiplication and division factor
 Averaging and Start Delay for frequency meter
 Input modes:
Pulse counter: cnt.dir, up.dn, up.up, quad, quad2,
quad4, A/B, (A-B)/Ax100%
Frequency meter: A, A – B, A + B, quad, A/B,
(A-B)/Ax100%
Timer: FrErun, Auto, InpA.InpB, InpB.InpB
 Output operations:
Add, Sub, AddAr, SubAr, AddBat, SubBat, AddTot,
SubTot, Trail, TrailAr
 4-stage RESET mode
 3-stage keypad locking (Lock)
 MPI input for Display Latch, Teach-In or Set
function
 Supply voltage 90 .. 260 VAC or
10 .. 30 VDC
4 Display/Operating elements
1
6-digit LED display
2
Status display LED1 / LED2
3
RESET key / ENTER key
4 Key LEFT
5 Key UP
6 Key DOWN
7 Key RIGHT
5 Inputs
5.1 INP A, INP B
Signal inputs: function acc to operating mode.
Max. frequency 60 kHz, can be damped in the
programming menu to 30 Hz.
Pulse counter: Count inputs
Frequency meter: Frequency inputs
Timer: Start input or
Start/Stop inputs
5.2 RESET
Dynamic reset input: resets the pulse counter or
timer to zero (‘Add’ output operations) or to preset
value 2 (‘Sub’ output operations). The reset input
can be inhibited in the programming menu.
Pulse counter: RESET input
Frequency meter: no function
Timer: RESET input
5.3 GATE
Static gate input: function dependent on operating
mode.
Pulse counter: no counting while active
Frequency meter: no counting while active
Timer: no time measurement while
active
5.4 LOC.INP
Static keypad lock input for preset or programming.
Lock-out level can be set in the programming
menu.
5.5 MPI 1 / MPI 2
User Input. Programmable as Display Latch, Set or
Teach-In input.
6 Outputs
6.1 Output 1 / Output 2
Relays with potential-free changeover contacts.
6.2 Active Outputs
LED1 and LED2 indicate an active output.
For safety switching the relays can be inverted, i.e.
the relays will be de-energized when the presets
are reached. To do this, the parameters Pr.OUT1
and Pr. OUT2 must be set to
(for permanent
signal) and to
or (for timed signal).
e
n
g
l
i
s
h
Page 5
www.kuebler.com