Datasheet

71
SW7 [0,28]
0,25
8 0,31
0,16
0
,
2
8
7
m8
4
M4
R
30 1,18
0,16
www.kuebler.com© Fritz Kübler GmbH, subject to errors and changes. 07/2017
Incremental encoders
Mounting accessory for hollow shaft encoders Dimensions in mm [inch] Order no.
Cylindrical pin, long with fixing thread 8.0010.4700.0000
for flange with spring element
(flange type 1 + 2)
Isolation / adapter inserts for hollow shaft encoders order code 8.5020.X8XX.XXXX D1 Isolation insert
6 mm [0.24“] 8.0010.4021.0000
8 mm [0.32“] 8.0010.4020.0000
10 mm [0.39“] 8.0010.4023.0000
12 mm [0.47“] 8.0010.4025.0000
1/4“ 8.0010.4022.0000
3/8“ 8.0010.4024.0000
1/2“ 8.0010.4026.0000
Thermal and electrical isolation of the encoders
(Temperature range -40 ... +115°C [-40°F ... +239°F] )
Isolation inserts prevent currents from passing through the
encoder bearings. These currents can occur when using
inverter controlled three-phase or AC vector motors and
considerably shorten the service life of the encoder bearings.
In addition the encoder is thermally isolated as the plastic
does not transfer the heat to the encoder.
Incremental encoders
Connection technology Order no.
Cordset, pre-assembled M12 female connector with coupling nut, 8-pin
2 m [6.56‘] PVC cable 05.00.6041.8211.002M
M23 female connector with coupling nut, 12-pin
2 m [6.56‘] PVC cable 8.0000.6901.0002
Connector, self-assembly (straight) M12 female connector with coupling nut, 8-pin 05.CMB 8181-0
M23 female connector with coupling nut, 12-pin 8.0000.5012.0000
MIL female connector with coupling nut, 10-pin 8.0000.5062.0000
Further accessories can be found in the accessories section or in the accessories area of our website at: www.kuebler.com/accessories.
Additional connectors can be found in the connection technology section or in the connection technology area of our website at: www.kuebler.com/connection_technology.
Push-pull / RS422 / Open collector
Standard
optical Sendix 5000 / 5020 (shaft / hollow shaft)
Mounting accessory for shaft encoders Order no.
Coupling bellows coupling ø 19 mm [0.75“] for shaft 6 mm [0.24“] 8.0000.1102.0606
bellows coupling ø 19 mm [0.75“] for shaft 10 mm [0.39“] 8.0000.1102.1010