MIMOSA INSTRUCTION MANUAL MODEL 3302 12V Power Ratchet Wrench www.kimotool.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY LIMO TOOL, EMAIL US AT: General Safety Rules For All Tools WARNING! Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury. SAVE THESE INSTRUCTIONS! WORK AREA = Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents.
= Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, clothing, and gloves away from moving parts. Loose clothing, jewelry, or long hair can be caught in moving parts. = Avoid accidental starting. Be sure switch is off before plugging in. Carrying tools with your finger on the switch or plugging in tools that have the switch on invites accidents. = Remove adjusting keys or wrenches before turning the tool on.
= Check for misalignment or binding of moving pairs, breakage of parts, and any other condition that may affect the tool's operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly maintained tools. = Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool, may become hazardous when used on another fool. COMPONENTS AND SPECIFICATIONS G A. 3/8" Square Drive B. Dual Gauge C C.LED D D. Lock Switch E.
SPECIFIC INSTRUCTIONS A WARNING! Hold power tool by insulated gripping surfaces, when performing an operation where the fastener may contact hidden wiring. Fasteners contacting a “live"wire may make exposed metal pairs of the power tool “live” and could give the operator an electric shock. inserting / Removing the Battery To insert the battery, slide the pack into the body of the tool. Make sure it latches securely into place.
Attaching and Removing Accessories These tools are intended only for use with accessories designed for impact tools. Other sockets could shatter or break, causing injury.To attach a socket or other accessory, align the accessory with the drive warily and push it firmly onto the tool. To remove the accessory, pull the accessory off the drive anvil. Using the Forward/Reverse Toggle For forward (clockwise) rotation, Forward rotate the forward/reverse toggle counterclockwise.
Starting, Stopping and Controlling Speed To start the tool, pull the paddle switch. NOTE: An LED is turned on when the switch is pulled. The tool will shut off automatically when maximum torque is reached. To vary the driving speed, increase or decrease pressure on the switch. The further the switch is pulled, the greater the speed. To lock the paddle switch, slide the lock switch down to the paddle to reach locked position. To unlock the paddle switch, slide the lock switch up to the unlocked position.
Charge Battery To Charge the battery, align the battery pack with the bay and slide the battery pack into the charger as far as possible. The red light will come on, either flashing (battery pack is too hot or cold) or continuous (pack is charging). A fully discharged battery pack with an internal temperature in the normal range will charge minutes, depending on the battery pack and charger.
(3) Do not expose battery cartridge to water or rain. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. = Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 122.F, = Do not incinerate the battery cartridge even severely damaged or is completely worn out. The battery cartridge can explode in a fire. = Be careful not to drop or strike battery. = Do not use a damaged battery.
