User Manual

Setting the Depth Gauge

WARNING: Before connecting the tool to a power

supply, make sure the slider switch(4) is in the

off position by pressing the rear part of the switch

and releasing. Ensure the switch is in the off position

as described above after any interruption in power

supply to the tool, such as the activation of a ground

ffault interrupter, throwing of a circuit breaker, accidental

unplugging, or power failure. If the switch is locked on

when the power is connected, the tool will start unexp-

-ectedly.

To start the tool, slide the slider switch(4) toward the front of

the tool. To stop the tool, release the slider switch.

For continuous operation, slide the slider switch toward the

front of the tool and press the forward part of the slider switch

inward. To stop the tool while operating in continuous

mode, press the rear part of the switch and release.

To stop the tool while operating in continuous mode,

press the rear part of the switch and release.

SPINDLE LOCK

The spindle lock is provided to prevent the spindle from rotating

when installing or removing wheels. Operate the spindle lock only

when the tool is turned off, unplugged from the power supply,

and has come to a complete stop. Do not engage the spindle

lock while the tool is operating because damage to the tool will

result. To engage the lock, depress the spindle lock button and

rrotate the spindle until you are unable to rotate the spindle further.