Setup instructions

19766 Tablet PC stand holder
19766 »Biobased«
Information for use
Intended use
The tablet PC stand holder is above all designed to hold a tablet with 155-307 mm dimension.
Thanks to the threaded bolts with a 5/8" thread and the thread reducer with a 3/8" thread, moun-
ting on almost any microphone stand or table stand is possible. The inclination can be adjusted
to an angle of 90° via the joint. The clamping width can be easily and quickly varied or adjusted
via a clamping screw on the back.
Foreseeable misapplication
Do not transport the tablet PC stand holder with the tablet clamped. Please do not use the tablet
PC stand holder upside down.
General
u Use a suitable stand: The stand must have sufficient stability and load-bearing capacity. Using
u the tablet PC holder with an inserted tablet can affect the stability and unbalance the stand.
u Observe the instructions for use of the stand used.
u Set up and adjust:
u ● Attach the holder without the tablet to the stand and adjust to the desired position.
u ● The best stability is achieved when the tablet PC stand holder is aligned so that it is flush
u ● with or overlapping one of the stand feet.
u ● Loosening the clamping and adjustment screw when the tablet is still clamped, is only per-
u ● mitted to make small corrections to the position. Increased caution is required when making
u ● this correction to prevent the unit from falling down unexpectedly.
u Falling over or dropping the tablet PC stand holder can cause personal injury and damage to
u property.
u There is a risk of crushing between the components due to the possibility of adjustment.
u The user must be physically and professionally fit.
u The usage information is an integral part of the product and should be kept for its service life
u or passed on to any subsequent owner or user.
Warranty
No warranty is given for damage caused by:
u Non-observance of the usage information and the "General safety and assembly instructions".
u Unsuitable or improper use.
u Incorrect installation or commissioning by the buyer or third parties.
u Natural wear and tear.
u Careless handling.
u Improper modifications or repair work by the buyer and third parties.
u Impact on components of foreign origin.
u Use of non-original spare parts.
Modifications, additions and conversions that may impair safety are prohibited without the manu-
facturer's approval.