Owner's Manual

9. MOUNT THE LOUDSPEAKER
11. CHECK, MAINTENANCE, CLEANING
- When using the mount at "events and production sites for scenic presentations" BGV C1 applies accordingly.
- In the event of system maintenance pay attention to possible risks (wedging/pinching, it is hit or bumped into, falling objects) and ensure
- against such risks, accordingly.
- To care for the product use a damp cloth and a non-abrasive cleaning agent.
FAULT FINDING (F) and SOLUTION (S)
F: Mounting parts are not stable: S: Tighten the screws.
F: Loudspeaker sways back and forth on the locking pin: S: Tighten the nut beneath the locking pin / bushing greater than 37 mm.
F: Loudspeaker cannot be positioned: S: see Section 10: POSITION LOUDSPEAKER
a. Place the speaker with the flange adapter on the locking bolt/pin of the support arm.
a. - set the speaker in the desired direction.
b. remove the protective cap 1.
c. Tighten the 2 nut, this presses the end of the locking plates to the internal wall of the loudspeaker connector.
c. ATTENTION: such placement may not be done by hand and would represent IMPROPER USE.
c. - Place the protective cap on the nut.
10. REPOSITION OR REMOVE THE LOUDSPEAKER
d. - Remove the protective cap
d. - loosen the nut, but do not remove it completely
e. To release the wedge locking plates from the loudspeaker it is necessary to hit the bolt with a rubber mallet to loosen the wedge lock.
e. This is to be done by carefully hitting from the bottom - in the axial direction towards the threaded bolt, so that the wedge locking plates loosen.
f. The loudspeaker can be repositioned or removed from the locking pin.
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
24110-000-55 Rev.08 03.80.335.00 7/14
TECHNICAL DATA / SPECIFICATIONS
Material
tubes and brackets - steel, black powder coating
screws, nuts - steel, galvanized
cover, locking plates - PA, PE
Load max. 50 kg
Dimensions H x W x D: 460 x 126 x 512 mm, socket pins: ø 35-37 x 85 mm
Karton H x W x D: 85 x 145 x 540 mm
Weight net 2.8 kg / gross: 3.0 kg
Accessories adapter sleeve 21326: for loudspeaker bushing with 38 mm internal diameter (= US variation)