Owner's Manual

10. INSTALLING THE LOUDSPEAKERS
12. INSPECTION, MAINTENANCE, CLEANING
- "When using the bracket at staging and production facilities" the German Accident Prevention Regulations BGV C1 apply.
- When maintaining the bracket, be aware of potential hazards (pinching, knocking, falling objects, etc.) and take suitable precautions.
- For cleaning purposes utilise a slightly damp cloth with a non-abrasive cleaning solvent.
FAULT FINDING (F) and SOLUTION (S)
F: Bracket components wobble: B: tighten connections.
F: Loudspeaker sways on the socket pin: B: tighten the bolt below the socket pin / bushing size 37 mm.
F: Loudspeaker cannot be turned: B: see section 10: TO TURN OR RELEASE THE LOUDSPEAKER
a. Place the speaker with the flange bushing on the socket pins of the support arm.
a. - turn the speaker to the required position.
b. Remove the protective cap 13.
c. Tighten the nut 14 with the key until the socket pin guiders are pressed to the inner wall of the loudspeaker bushing.
c. NOTE: When the loudspeaker has been positioned, it can NOT BE TURNED by hand and on no account should you
c. attempt to turn the speaker.
c. - Replace the cap on the bolt.
11. TO TURN or RELEASE THE LOUDSPEAKER
d. - Remove the protective cap
d. - loosen the bolt, but do not remove completely
e. Use a rubber hammer to strike the socket pin and release the wedged guiders. Carefully remove from below in the direction of the
e. axis and onto the thread so the guiders release.
f. The loudspeaker can now be turned again, i.e. dismantled from the socket pin.
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
24120-000-55 Rev.08 03.80.338.00 7/14
TECHNICAL DATA / SPECIFICATIONS
Materials
wall plate, sections and brackets - steel, black powder-coated
screws, nuts - steel, zinc-plated
covering, guiders - PA, PE
Load max. 50 kg
Dimensions H x W x D: 498 x 140 x 530 mm, socket pins: ø 35-37 x 85 mm
Carton H x W x D: 85 x 145 x 540 mm
Weight net: 6.2 kg / gross: 6.4 kg
Accessories adapter sleeve 21326: for loudspeaker bushing with 38 mm internal diameter (=US variation)