User's Manual

The Guardian™ Instruction Manual
Note
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
We’re Here to Help
Toll Free: 1-800-657-8214
Outside US: 1-541-245-4488
Caution
Changes or Modications not expressly approved by the party responsible could void the
user’s authority to operate this device.
Warning
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries
according to the instructions. This product needs power supplied by an adapter that can
meet LPS. The maximum operating temperature is 45°C.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Website: www.pestrepellerultimate.com
Email: [e-mail]
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en comprom-
ettre le fonctionnement.
©2014 Good Life, Inc. DESIGNED IN OREGON MADE IN CHINA
Power Options Optional Accessories (Sold Separately)
The Guardian™ can be powered by 6 C size batteries or by an
AC adapter. To install batteries, remove the two screws that
hold the cover in place and remove the cover. Install the batter-
ies as shown and replace the cover.
When using the optional AC adapter, plug the adapter into the
wall. Lift the rubber ap on The Guardian™ and attach the cord.
Remote Control
Use the remote control to activate The Guardian™ if the pest is
outside the motion detector range or too small to trigger the
unit automatically.
Strobe Light
The Strobe Light connects via a small 2-pin plug and twists on
top of The Guardian™. This optional accessory produces regular
ashes of light that are irritating to nocturnal animals and can
be used indoors or out.
Installing The Guardian™
1) Identify where your pest problem is.
2) Adjust the control panel based on your particular pest
problem (see Control Panel section for further directions)
3) Place The Guardian™ at the pest’s level. If targeting smaller
pests, put The Guardian™ lower to the ground and higher for
large pests.
4) Do not place the Guardian™ directly in standing water.
5) Ensure there are no solid objects directly in front of The
Guardian™ that might block the ultrasonic sound.
6) Monitor pest activity over the next week. Adjust the control panel
settings as necessary. Allow up to 2 to 3 weeks for best results.
OPTION 1: Battery Installation
OPTION 2: AC Adapter
Specications
Sound coverage: 6,000+ sq. ft.
(Sound does not travel through solid barriers.)
Infrared motion sensor range: Up to 100ft.
Dimensions: 6.7”H x 5.4”W x 3.1” D
Power Source: AC adapter (5ft., not included)
6X C batteries (not included)
Audio output: +95db
Power consumption: 1.8W