Installation Manual

INSTALLATION INSTRUCTIONS
Continued
13. Using the provided spacer, install the tube
mounting bracket assembly onto the engine as
shown.
14. Install the silicone hose (08630) onto the throttle
body and secure with the provided hose clamp as
shown.
15. Remove the air temperature sensor from the
factory intake tube.
16c. On SRT 8; 6.1L equipped vehicles, install the
provided grommet into the 0.75” ID hole as shown.
16d. On SRT 8; 6.1L equipped vehicles, install the
provided 90° hose mender as shown.
17. Install the factory air temperature sensor into the
grommet installed in step #16.
20. Install the fi lter adapter into the air fi lter and
secure with the provided hose clamp.
21. Install silicone hose (08630) onto the air fi lter as-
sembly and secure with the provided hose clamp.
22. Install the air fi lter assembly onto the K&N
®
intake tube and secure with the provided hose
clamp as shown.
11. Install the heat shield assembly into the vehicle
and secure to the bracket installed in step #8. Then
secure the “L” bracket with the factory bolt removed
in step #6 to the air box mounting location.
12. Assemble the tube mounting bracket and saddle
clamp as shown with the provided hardware.
10. Install the two pieces of edge trim onto the
heat shield as shown, be sure to leave a gap at the
bracket mounting locations.
19. Install the provided crankcase vent hose onto
the vent port on the valve cover then install the vent
hose onto the K&N
®
intake tube.
19a. On SRT 8; 6.1L equipped vehicles, connect
the factory crank case vent hose onto the 90° fi tting
installed into the K&N
®
intake tube (in step #16c).
18. Install the K&N
®
intake tube into the throttle
body and onto the saddle clamp as shown, then
secure with the hose clamps provided.
16b. Drill out the hole in the intake tube to 0.75”.
16a. On SRT 8; 6.1L vehicles, cut the vent off of the
K&N
®
intake tube as shown.
16. Install the provided grommet into the K&N
®
intake tube as shown.