Installation Manual
INSTALLATION INSTRUCTIONS
Continued
10. Install the provided rubber insert onto the heat
shield as shown and secure with the provided
hardware.
11. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
12. Install the provided silicone hump hose (08418)
onto the lter adapter and secure with the provided
hose clamp.
13. Set the heat shield assembly into position in
the engine bay so the rubber insert passes into the
air box mounting hole in the inner fender. Do not
secure the heat shield at this time.
14. Install the silicone step hose (08497) onto the
throttle body and secure with the provided hose
clamp.
15. Remove the inlet air temperature sensor from
the factory intake tube as shown.
16. Install the provided grommet and the factory
inlet air temperature sensor into the K&N
®
intake
tube as shown.
NOTE: Be sure to remove the factory o-ring
before installing the inlet air temperature
sensor.
17. Install the provided 90° vent tting into the
K&N
®
intake tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
18. Install the K&N
®
intake tube into the silicone
hump hose and then into the silicone step hose
at the throttle body. Align the intake tube and heat
shield for proper t and then secure the intake
tube with the provided hose clamps and the heat
shield bracket with the factory air box retaining bolt
removed in an earlier step.
19. Cut the provided ½” silicone vent hose to a
length of 9” long, and cut the 5/8” vent line to a
length of 2.5” long.
20. Assemble the two vent lines together using the
provided hose mender.
21. Install the assembled vent hose onto the tting
installed in the K&N
®
intake tube and then attach
the open end to the valve cover port.
22. Reconnect the inlet air temperature sensor
electrical connection.
23. Reinstall the coil cover.
24. Install the K&N
®
air lter and secure with the
provided hose clamp.
NOTE: Drycharger
®
air lter wrap; part #
RF-1042DK is available to purchase
separately. To learn more about Drycharger
®
lter wraps or look up color availability please
visit http://www.knlters.com
®
.