Installation Manual

INSTALLATION INSTRUCTIONS
Continued
32. Reconnect the vehicle's negative battery
cable. Double check to make sure everything is
tight and properly positioned before starting the
vehicle.
33. It will be necessary for all K&N Performance
Intake Kit’s to be checked periodically for realign-
ment, clearance and tightening of all connections.
Failure to follow the above instructions or proper
maintenance may void warranty.
ROAD TESTING:
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function iden-
tically to the factory system except for being louder
and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and fix as necessary.
3. If road test is fine, you can now enjoy the added
power and performance from your kit.
4. K&N suggests checking the Air filter element
periodically for excessive dirt build-up. When the
element becomes covered in dirt (or once a year),
service it according to the instructions on the
Recharger service kit, part number 99-5050 or 99-
5000.
P.O. BOX 1329, RIVERSIDE, CA, 92502 USA [phone] FAX [phone] TECH: [phone] http://www.KNFilters.com e-mail: [e-mail]
17561d
1/7/09
*FREE K&N DECAL To register your warranty, please see us online at knfilters.com/register. FREE K&N DECAL*
14. Remove the two valve cover bolts shown.
NOTE: These bolts will be reused.
15. Install the tube mounting bracket assembly
onto the valve cover using the factory bolts
removed in step #14.
16. Install the provided silicone hose (08756)
onto the throttle body and secure with the pro-
vided hose clamp.
17. Remove the two mass air sensor-retaining
screws and then remove the mass air sensor
from the factory air box.
18. Install the supplied gasket onto the mass air
sensor adapter as shown.
19. Install the mass air sensor into the K&N
mass air adapter and secure with the provided
bolts as shown.
20. Install the mass air sensor assembly into the
K&N intake tube with the supplied hardware as
shown.
NOTE: Be sure to install the mass air sensor
with the opening towards the filter inlet end
of the intake tube.
21. Install the supplied npt fitting into the K&N
intake tube as shown.
22. Install the K&N intake tube onto the throttle
body and align with the saddle bracket.
23. Secure the K&N intake tube to the saddle
bracket with the provided hose clamps also
tighten the hose clamp at the throttle
24. Install the provided vacuum hose onto the
fuel pressure regulator and then onto the K&N
intake tube as shown.
25. Install the provided crank case vent hose
onto the valve cover port and then onto the
K&N intake tube as shown.
26. Install the pressure sensor onto the K&N
intake tube using the bolts removed in step #3.
27. Install the radius filter adapter into the Air
filter and secure with the provided hardware as
shown.
28. Install the provided silicone hose (08724)
onto the Air filter assembly and secure with the
provided hose clamp as shown.
29. Install the K&N Air filter onto the intake
tube as shown.
30. Clip the mass air sensor wire harness
retainer into the tube-mounting bracket as
shown.
31. Reconnect the mass air sensor electrical
connection as shown.