Installation Manual

INSTALLATION INSTRUCTIONS
Continued
14. Remove rubber coupler from resonator tube
assembly.
15. Remove the upper air inlet duct as shown.
16. Remove the bolt that secures the lower air inlet
duct to the bracket on the inner fender as shown.
NOTE: The bolt may be accessible from
underneath the vehicle. Then remove the
secondary bolt that secures the bracket and
remove the bracket.
17. From underneath the vehicle remove the
resonator inlet duct, which is secured by a bolt to
the resonator.
18. Remove the two bolts that secure the resonator
to the inner fender, then, remove the resonator as
shown.
19. Install the silicone hose and hose clamps onto
the throttle body and tighten as shown.
20. Install the provided rubber mounted stud into
the original air cleaner mounting hole on the battery
tray as shown.
21. Using the provided hardware secure the
provided bracket onto the K&N
®
short ram tube as
shown.
NOTE: Before installing the bracket, inspect
the inside of the tube for any debris, then clean
the inside out with water and a towel. Inspect
the tube one more time before proceeding to
the next step.
22. Install the silicone hose into the vent on the
K&N
®
short ram intake tube as shown.
23. Slide the K&N
®
short ram intake tube into the
silicone hose on the throttle body, then, slide the
crankcase vent hard line into the vent on the intake
tube as shown, but do not tighten at this time.
24. Secure the bracket to the rubber mounted stud
and secure it with the provided hardware as shown
but do not tighten at this time.
25. Slide the silicone hump hose onto the K&N
®
short ram intake tube as shown, but do not tighten
at this time.
26. Install the provided rubber mounted stud into
the original resonator mounting hole as shown.
27. Install the provided bracket onto the threaded
boss on the K&N
®
cold air intake tube and secure
with the provided hardware as shown.
NOTE: Before installing the bracket, inspect
the inside of the tube for any debris, then clean
the inside out with water and a towel. Inspect
the tube one more time before proceeding to
the next step.
12. Remove the lower spoiler ap which is secured
by two bolts as shown
13. Remove one bolt and four plastic rivets, then,
pull the inner wheel valance back and down as
shown.
11. Raise the vehicle up and support it with jack
stands, then, remove the front tire as shown.
10. Slide the lower air cleaner assembly off of the
air inlet duct and remove the lower air cleaner
assembly as shown.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.