Installation Manual

ManualsBrandsK&N ManualsAutomotiveK&N 69-1008TB Typhoon Air Intake Kit, Short Ram, Blue

69-1008TS

69-1008TB

TOOLS NEEDED:

NOTE: FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED HARDWARE

MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE.

1. Turn off the ignition and disconnect the negative

battery cable.

NOTE: Disconnecting the negative battery

cable erases pre-programmed electronic

memories. Write down all memory settings be-

fore disconnecting the negative battery cable.

Some radios will require an anti-theft code to

be entered after the battery is reconnected. The

anti-theft code is typically supplied with your

owner’s manual. In the event your vehicles’

anti-theft code cannot be recovered, contact an

authorized dealership to obtain your vehicles

anti-theft code.

TO START:

PARTS LIST:

Description Qty. Part #

™

2. Disconnect the air temperature sensor electrical

connection as shown.

NOTE: C.A.R.B. E.O.# D-269-32

APPLIES ONLY TO L4-1.7L MODELS

Flat Blade Screwdriver

Ratchet

3” Extension

6” Extension

14” Extension

8mm Socket

10mm Socket

Pliers

4mm Allen Wrench

A Filter 1 RU-4950

B Hose clamp, #40 3 08554

C Rubber mounted stud 1 07027

D Flat washer 1 08269

E 6mm Nylock Nut 1 07512

F Intake Tube 1 087036-1

G Silicone Hose, 5/8” x 5”L 1 08538

H Grommet, 5/8” ID 1 08283

I Silicone Hose, Black 1 08284

3. Unclip the battery cable from the air inlet duct as

shown.

4. Loosen and remove the two bolts that secure the

air inlet duct as shown.

5. Remove the air inlet duct.

6. Loosen and remove the four bolts that secure

the air intake resonator.

7. Loosen and remove the two bolts that secure the

throttle body plenum.

8. Loosen the hose clamp that secures the plenum

to the throttle body as shown.

9. Using a pair of pliers, depress and pull back

the hose clamp on the crankcase vent at the cam

cover.

HONDA

2001-05 Civic

L4-1.7L / 1.6L

Summary of content (2 pages)

PAGE 1
™ 69-1008TS 69-1008TB HONDA 2001-05 Civic L4-1.7L / 1.6L NOTE: C.A.R.B. E.O.# D-269-32 APPLIES ONLY TO L4-1.7L MODELS TOOLS NEEDED: Flat Blade Screwdriver Ratchet 3” Extension 6” Extension 14” Extension 8mm Socket 10mm Socket Pliers 4mm Allen Wrench PARTS LIST: A B C Description Filter Hose clamp, #40 Rubber mounted stud Qty.
PAGE 2
INSTALLATION INSTRUCTIONS Continued 10. Pull firmly upwards to remove the throttle body plenum as shown. 16. Remove the air temperature sensor from the throttle body plenum as shown. 11. Using a flat blade screwdriver, unclip the wire harness from the resonator as shown. 17. Install the provided rubber grommet into the hole on the K&N® intake tube, then install the air temperature sensor into the grommet as shown.