Installation Manual

INSTALLATION INSTRUCTIONS
Continued
11. Using pliers, remove the coolant hose from the
thermostat housing and the throttle body adaptor
(a small amount of coolant may drain, have a cup
ready to catch the uid).
12. Install the provided coolant hose and secure
with provided hose clamps.
13. Install the silicone hose and hose clamps onto
the throttle body as shown.
14. Loosen and remove the two screws that hold
the MAF sensor to the factory airbox and remove
the MAF sensor.
15. Secure the MAF sensor to the K&N
®
intake
tube with the provided hardware.
16. Attach the “Z” bracket to the K&N
®
intake tube
using the provided hardware.
17. Install the K&N
®
intake tube into the vehicle. At-
tach the bracket to the threaded hole from the
factory airbox mounting point. Tighten hose clamps
at the throttle body.
18. Secure the rubber mounted stud onto the other
factory airbox mounting point.
19. Install the “L” bracket onto the rubber mounted
stud as shown.
20. Attach the large edge trim around the heat
shield as shown. Install the small edge trim into the
inner hole. It will be necessary to trim the edge trim
for proper t.
21. Loosen the positive battery cable and unclip
the battery wire harness, adjust battery cable as
shown. Then resecure the battery.
22. Unclip hydraulic line from clip and then remove
the clip from the vehicle.
23. Slide the provided hose clamp onto the
K&N
®
intake tube, then install the heat shield.
NOTE: On automatic transmission equipped
vehicles, it will be necessary to remove the air
lter and heat shield from the vehicle to check
the transmission uid level.
24. Install clip to the hydraulic line then attach to
hole in heat shield.
15a. Install the provided venturi into the end of the
intake tube as shown.
NOTE: Apply a thin coat of the provided super
glue to the lip of the venturi.
25. Attach the “L” bracket to the heat shield, and
then install a bolt through the the hole on the ECU
bracket to the threaded boss on the heat shield.
Then attach the factory air inlet hose to the heat
shield.